It won't start

https://www.youtube.com/watch?v=cmcsA2jr4yU

Here is a how to video to reset the pin. Good luck

Have you tried different web browsers, like firefox, chrome?

My singer hasn't wound bobbins for years and I don't care because I use a Side Winder bobbin winder. It's much easier than takining the thread off the machine anyway. Available from Hancock, Jo Ann or even Wal Mart for about $30.

then install the windows-07 this will keep the windows old files in a saperate folder.. try this once it may help you i think.. because you dont want to buy new harddisk and its having data...

Check the coils that have been replace for bent or broken prongs that plug into the ignition control module and if nothing looks damaged then i would think the ignition control module is faulty.Replace ignition control module.

You've to replace the ac adapter, if it's brick doesn't get warm or LED does not glow on Power Jack on the laptop. offcourse, check with the wall different sockets

power jack can also be loose. so jiggle the cable to find out.

if notebook is getting power, you can remove the battery, ac adapter, hold and keeep pressing poer button for a minute, then, turn it on.

finally, you can take out hdd and ram, put them back again and turn on the laptop. hope it will help

Nikon hasn't manufactured the N65 is several years now, so if you bought it it was either misrepresented as new, or possible new-old-stock (a never sold/used item, that's been sitting on the shelf for a number of years). I'd be willing to venture you probably ran into a disreputable seller.

Either way, open the battery compartment and look for corrosion in the compartment. If that's present clean it off with the eraser of a pencil and try again. If that doesn't work, contact Nikon service with the warranty information in your package. If it's a new item, it'll still be warrantied since the warranty won't begin until it's sold to a consumer.

If, however you find that the camera was sold 10 years ago and no longer under warranty, you'll probably want to either find a local reputable shop, buy another camera if yours turns out to be too expensive to repair (impossible to tell until someone looks at it to determine the issue), or if you don't have a local shop I'd recommend KEH Camera in Atlanta, GA for mail-order/internet dealers. They've been in business many years and are very reputable.

If new X2772 tripper hasn't solve problem, it might be time for new timer.
http://waterheatertimer.org/Paragon-timers-and-manuals.html#4000

4001-00 is 120Volt single pole single throw timer in Nema1 indoor enclosure
Wiring terminals 1 2 3
Black Hot wire from breaker connects to terminal 1
Black wire going to load connects to terminal 2
White neutral wires connect to terminal 3

Crossover Intermatic timer is T101
http://waterheatertimer.org/How-to-wire-T104-Intermatic-timer.html#T101
Wiring terminals A 1 2
Black Hot wire from breaker connects to terminal 1
Black wire going to load connects to terminal 2
White neutral wires connect to terminal A

hello matt.... the most common cause of no heat is a burned out heating element. Replace it and you should have heat again. Joe

change the starter motor.