Top 20
Thermador C272 Electric Double Oven Questions & Answers
Unit shuts off when using broiler
can't broil with door open with these models. If closed, most likely an air flow issue with the cooling fan above in the control panel.
Oven takes forever to heat up
Hello- Check these things first- Door seals tend to get stiff over time. This is normal. Door hinges can become loose or get bent a bit, causing door to not close tight. This little gap can allow heat to escape, causing extended pre-heat times and frequent cycling of elements. If door doesn't seem to pull shut tightly- hinges will need to be replaced. If oven appears to operate normally otherwise, this should solve problem. Let me know if the info helps- have more if needed- Thanks - Ed
Self-clean turns off after 5 minutes with F2 error message
Hi MaryB,
F2 error code means that the oven temperature is too hot. You will have to replace relay board if faulty. Check and replace oven temperature sensor (RTD). If failure repeats, replace ERC (electronic range control or clock).For replacement part you may contact Sears at 1-800-252-1698; M-F 6:30 AM-10:30 PM - Sat 7:00 AM-9:30 PM - Sun 7:30 AM-9:30 PM - All times Central.
Hope this helps.
Thank you for using FixYa.
After a power outage the
You need a surge suppression device on the oven...It is hard to do that so were do you put it. On the main distibution panel.
Not a lightning Arrestor. It is not a Surge suppressor. A lightning arrestor only keeps the wires from burning up, and a surge suppression deivce not only does that but keeps your stuff from blowing out like it did.
PTS-240HUL-L will cost you $268.00 and I have one in stock.
A electrician will cost you $50.00 in a non-union state and in a Union state about $100.00 to do the install...if you sweet talk him into it.
www.storminprotection.com
Temp probe indicator stays on
sounds like your probe connection may be shorted. Can you inspect the probe itself, and perhaps do a test for continuity with an ohm meter? Also, you might be able to disable the probe in the menu settings, and run it on manual, just for a test.
Do you still have the user's manual for this unit?
Not finding what you are looking for?