20 Most Recent Thermador C272 Electric Double Oven Questions & Answers

try rebooting; unplug or switch off the circuit breaker for 90 seconds

Thermador Appliances ' Frequently Asked Questions ' Use ...

www.thermador.com/faq/categories.php?categoryid=53

ThermadorContact us for help with service & repair needs. ... The anti-tip bracket is not needed for 48" Harmony units. However, the anti-tip ... Oven light is not working properly. Replace ... Buy a replacement bulb. View the ... The rack positions that you would use when baking 3 racks in the convection mode would be racks 1,2 and 4.

Thermador Range/Stove/Oven Parts - RepairClinic.com

www.repairclinic.com/Shop...Parts/.../Thermador-Range-Stove-Oven-Par...

Huge selection of Thermador Range/Stove/Oven parts in stock. Same day ... Stove top potentiometer Kit that contains 2 potentiometer's and 1 simmer controller.

[PDF]for Thermador Professional Series Built-in Wall Ovens

www.msaworld.com/.../Service-Manual-Therm-Pro-BIWO_RevA3.pdf

can't broil with door open with these models. If closed, most likely an air flow issue with the cooling fan above in the control panel.

bad solder joint at relay board where the fan wires connect.

bad solder joint on the relay board where the wires from the fan plug into it.

door switch error

self cleaning ovens need temp set to highest to clean.

Hello,Note that lower oven cooling fan air switch not detected and that means you have to replace air switch,replace cooling fan,check connections,check P6 on PCB control display.
Thanks

http://appliantology.org/topic/33472-thermador-cm302us-upper-door-latch-instructions/page__gopid__207323

Hi,
If your electric oven is taking too long to heat or just not heating up right,then check out this tip that will give more detail about your problem.

Oven Problems Electric Oven is Heating Slowly or Poorly

heatman101 l';'

][

Hi MaryB,

F2 error code means that the oven temperature is too hot. You will have to replace relay board if faulty. Check and replace oven temperature sensor (RTD). If failure repeats, replace ERC (electronic range control or clock).For replacement part you may contact Sears at 1-800-252-1698; M-F 6:30 AM-10:30 PM - Sat 7:00 AM-9:30 PM - Sun 7:30 AM-9:30 PM - All times Central.

Hope this helps.

Thank you for using FixYa.

Hi,

If your electric oven is taking too long to heat or just not heating up right, then check out this tip that will give more detail about your problem.

Oven Problems Electric Oven is Heating Slowly or Poorly

heatman101

Hello- Check these things first-  Door seals tend to get stiff over time. This is normal. Door hinges can become loose or get bent a bit, causing door to not close tight. This little gap can allow heat to escape, causing extended pre-heat times and frequent cycling of elements. If door doesn't seem to pull shut tightly- hinges will need to be replaced. If oven appears to operate normally otherwise, this should solve problem.  Let me know if the info helps- have more if needed- Thanks  - Ed

You need a surge suppression device on the oven...It is hard to do that so were do you put it. On the main distibution panel.

Not a lightning Arrestor. It is not a Surge suppressor. A lightning arrestor only keeps the wires from burning up, and a surge suppression deivce not only does that but keeps your stuff from blowing out like it did.

PTS-240HUL-L will cost you $268.00 and I have one in stock.
A electrician will cost you $50.00 in a non-union state and in a Union state about $100.00 to do the install...if you sweet talk him into it.

www.storminprotection.com