Coleman Powermate Powermate 5000W Generator "test output motor" Questions

...output. Brushes are fine. Does anyone have a test procedure for testing Field excitation. Also would like to find a manaul for it Check the voltage sent to the field when running. It will probably be ...

...output fuse or circuit breaker? If you can check for voltage directly from the stator or armature and check the results. Nothing? If it has them, could be brushes. Also, if it's a fuse, don't just do ...

MOTOR RUNS FINE IT PUTS OUT 110V BUT AFTER 10 MIN 0R MORE WILL DROP DOWN TO 90V Much will depend on the design of the alternator and how the rotor is energised and/or how the output is controlled. ...

...output. I tested the voltage with a Fluke volt meter and it showed 240 Volts+ then lowered the RPM and it then was putting out around 119 Volts. It seemed to vary directly with the RPM. Is my voltage ...

output? Has less than 150 hours although 11 years old. Motor runs great propane but shuts off every 15-18 seconds. Checked murphy switches oil & temp and they are fine. Notice generator is not putting

...output starts all over again. The green light remains on throughout. This fault is apparent with or without the smart switch on, I have checked the stepping motor and this seems fine. This fault does ...

...output. Brushes are fine. Does anyone have a test procedure for testing Field excitation. Also would like to find a manaul for it Well, its not exactly a published procedure, but this is what I would ...

output of the charger with a DC voltmeter. Simply press the test leads to the battery posts and some value above 11.5 volts (11 - 12.75 volts may not be uncommon).  Look at the chart below to get

...output and will not even run a drill. Does it need to be re-magnatized or flashed? If so, how would that be done? Field Flashing of Portable Generators This tip comes from the Briggs & Stratton ...

...test is to just see if there is output at the power wires that go to the transfer switch from the generator. The thing you don't say that ought to be happening is that the control board should crank ...