Question about Brother HL Office Equipment & Supplies
...print. Replaced the drum and new toner installed but still getting the marks along the right side of the print out. Sounds like you have a bad fuser assembly if the drum unit didn't solve the
Question about Brother HL Office Equipment & Supplies
...side of the page. How do I fix this? This printer can't print yellow! Maybe the paper does not move enough in the exit section and the sheet is burned from the fuser(thats why is yellow). This may be ...
...bad toner and drum issues. They are very finicky about paper quality. What happens is when a lower quality paper is used the higher paper dust and talc gets caught up in the charging brushes of the ...
...bad fixing unit (AKA fuser). The folded paper makes me think that it's most likey a fuser problem but you can check by opening the rear door and looking for two rollers that are about as thick as two ...
...ON LEFT HAND SIDE DOWN THREE QUARTERS OF SHEET. Most likely this is caused by a bad fuser, which can be replaced. Depending on the printer model it might be more economical just to buy a new
bad fuser??? Left side of page is dark and fades to a mirrored image on the right with identical results on the back of the page. I've replaced the drum and toner cartridge, ensured the corona wire is
...side, which is probably pointing to "A" on the scale (A, B, Envelope). Move both levers to "Envelope" and close the back panel. The troubleshooting manual says the levers should be moved back to "A" ...
Question about Brother HL Office Equipment & Supplies
...side of the unit before pulling it out). Find the little solenoid on it that pulls the density sensor door open and you will see it will stick to the tape on the solenoid (bad design on Brother's ...
Question about Brother HL Office Equipment & Supplies
...side of the page does not print. Hello Probablly the laser sendiing unit is dirty. Take out the toner look up at inside there is a place in the top inside above the drum in the middle carfully wipe ...
Question about Brother HL Office Equipment & Supplies
...side a few times to clean the charge wire. If that clears it up or improves the quilty of the prints than you probably have a bad toner. If it doesn't get any better then you probably are going to ...
488 questions posted
Usually answered in minutes!
1,072 Questions
495 Questions
422 Questions
249 Questions
188 Questions