Need motor mounts for 2004 Chrysler Pacifica

its located near the battery , generally inside front bumper driver side

front motor mount is the mount at the front of the engine not the front of the car

Personal experience says you have a wiring harness that is grounding out and causing the codes...This is especially true if you have had the typical motor mount issues that are common on the Pacifica...Check the wiring harness behind the drivers side wheel...


Remove the front left wheel (drivers side)
-Remove the wheel well shield (just the front is all that is necessary...fold it back)


-Verify the vehicle ground is still intact (when the motor mount gives there is not enough slack in the ground wire and the wire will pull out of the grounding lug)


-Inspect the wiring harness that is around the transmission that goes to the PCM (when the motor mounts give they can crush and then rest on the harness and wear through the casing and then affect the individual wires...throwing codes...)

Connect a jumper cable from negative on the battery and the other end to the engine block. If it starts look for a broken ground wire under air cleaner box from engine to motor mount or directly in the center front of the engine. The ground in front has a wire attached to it.
Good luck

My 2005 Chrysler Pacifica is shaking still after I took it to a repair shop they fixed the motor mount front left and said that I have to get the engine mount right, left , front and rear, transmission mount engine mount front right. How many mounts are there.

Transmission malfunction. Not something to mess around with. Delaying having it checked could cost big money later. personally, I'd take to dealer, but if you have a transmission shop you trust, your choice. Remember, a diagnosis is only an estimate, you don't have to have it repaired there if not comfortable.

1. Disconnect and isolate the battery negative cable.

Front Wiper Module - Remove/Install

1. Remove the wiper module.

Front Wiper Motor Mounting

1. With wiper module on bench, pry apart the socket and ball joint at the end of the bell crank .
2. Remove the three front wiper motor mounting bolts and remove motor from module/linkage.

INSTALLATION

1. Position the wiper motor into wiper module and install the three front wiper motor mounting bolts.
2. Press the socket and ball joint together on end of bell crank.
3. Install the wiper module.
4. Connect the battery negative cable.
5. Verify vehicle and system operation.
6. Close hood.

are there any other parts i need to move, in replacing front motor mounts for 2005 pacifica

3.5L engine?

you need to get the motor mounts changed as i had the same problem before....two of them had broke so anytime my car accelerated or slowed down the transmission going through its gears would cause the motor to jump....i would recommend taking it to a mechanic