Front motor mount needs replacement

should I replace A/C Heater blower motor? Take it to a qualified repair shop an have diagnosed .

My 2005 Chrysler Pacifica is shaking still after I took it to a repair shop they fixed the motor mount front left and said that I have to get the engine mount right, left , front and rear, transmission mount engine mount front right. How many mounts are there.

1. Disconnect and isolate the battery negative cable.

Front Wiper Module - Remove/Install

1. Remove the wiper module.

Front Wiper Motor Mounting

1. With wiper module on bench, pry apart the socket and ball joint at the end of the bell crank .
2. Remove the three front wiper motor mounting bolts and remove motor from module/linkage.

INSTALLATION

1. Position the wiper motor into wiper module and install the three front wiper motor mounting bolts.
2. Press the socket and ball joint together on end of bell crank.
3. Install the wiper module.
4. Connect the battery negative cable.
5. Verify vehicle and system operation.
6. Close hood.

There is not a mount on the front

you have to lift the engine out of the vehicle far enough to remove bolts this can be a complicated process

check the motor mounts first.

are there any other parts i need to move, in replacing front motor mounts for 2005 pacifica

Usually squeaks are rubber bushings that need liquid soap lubrication. The anti-roll bar bushings and end links are common sources. So is the lower arm bushings that work with the strut assembly. Suggest getting under the car while someone pushes down on the front end to get it squeaking. Good luck!

There are 4 motor mounts on a Neon. You need a jack to support the bottom of the motor with a block of wood on it. 2 are easily replaceable, but there is one that goes to the middle of the front of the engine that is tricky, plus the transmission mount is accessed after removing several components, like the battery and tray. It may be better to have a professional take care of those "tricky" mounts.

I'm thinking it has 1 motor mount and 2 dog bones. The mounts usually cost around $30 each and the dog bones $20-25 depending on the material their made of. You can replace these yourself, one at a time. The engine has to be jacked up just enough to take the weight off when you remove the mount. After you have it remove, install you new one/ones and tighten. After removing jack, torque the bolts to spec. Same thing is done with the dog bones. It a type of Motor mount that prevents the engine from leaning weight. These are usually located, one front/top engine area and one on bottom engine area.