Howm many motor mounts does 2005 pacifica have

front motor mount is the mount at the front of the engine not the front of the car

There is not a mount on the front

the map sensor is located at the top front of engine, it has a square plug with a wire lock, mounted at top end of intake manifold.

are there any other parts i need to move, in replacing front motor mounts for 2005 pacifica

CHECK BATTERY VOLTAGE FIRST SHOULD BE 12.5 VOLTS.IF NOT BATTERY WEAK.MAKE SURE BATTERY CABLES TIGHT CLEAN FREE FROM CORROSSION.FIRST TURN OFF RADIO BEFORE REMOVING NEGATIVE BATTERY CABLE TO KEEP FROM LOCKING OUT RADIO.IF BATTERY OKAY SOUND LIKE FAULTY STARTER SOLENOID.STARTER LOCATED NEAR FRONT MOUNT YOU HAVE TO REMOVE UPPER NUT FROM FRONT MOUNT,REMOVE LOWER FRONT MOUNT NUT,REMOVE LOWER BRACKET TO TRANSMISSION BOLT,REMOVE LOWER BRACKET TO ENGINE BLOCK BOLT,MOVE THE FRONT MOUNT AND BRACKET OUT OF THE WAY.THEN REMOVE ALL STARTER BOLTS AND THE STARTER POSITIVE BATTERY CABLE FROM STARTER SOLENOID.

3.5L engine?

And no one has the steps on how to replace this yourself. Its a pain and Chrysler will not warranty or re-call these cheap mounts. Ill be getting rid of my Pacifica soon.

I would say so, Just have to jack up the motor and loosen the mount, lift engine up enough to give you some room. There are two bolts that hold on the mount.

either your blower motor went bad or the blower motor resistor. what you can do is pull the plug from the blower motor and hook direct power from the battery and a ground, if the blower works replace the resistor the resistor will be mounted to the heater box close to the blower motor .follow the wires from the blower to the resistor. hope this helps

and? If you are asking what to do, have it welded before it gets worse.