Hazard flasher location on a 1992 Ford F150, and pictures

SOURCE: 1994 devilles flasher location

Turn signal flasher module is behind dash left of steering column near chime module. I have a 94 Seville and I had that same problem you need a Turn Signal Flasher Moduel, I forgot the proper term for it but I had to get mine replaced too. When I hit the signals to turn the side light would come on but the signal light wouldn't. Its a little box you get from Cadillac it only cost like $20 - $25 and you get it installed and trust. It'll work again. I just got mine done this week and my car now has turn signals again.

SOURCE: Turns signals do not work on 1992 Ford Thunderbird

I Have A 92 Thunderbird To And Its Located Above The Fuse Panel You Will Probally Need To Remove The Panel Under The Steering Column To Get To It Its Located To The Right of The Steering Column It looks Like A Relay Not The Normal Looking Round Style Flasher

SOURCE: location of pcv valve on 1992 ford f150

Which engine??? 4.6 and 5.0 liter rear of passenger valve cover

SOURCE: where is the turn signal\hazard flasher located?

it's in the auxiliary relay box behind the glove box.

13350 is base part number on flasher

Testimonial: "Actually found it located behind the radio mounted on a brace. Removed cover and relay pulls out. About 1" cube with 5 terminals on it."

ZJ Limited

• 17989 Answers
• Posted on Apr 02, 2010

SOURCE: 99 ford contour hazard flasher unit where is it

Flashers - REPLACEMENT

Turn Signal Flasher
(see Figure 1)



Fig. 1: The turn signal flasher is located on the multi-function switch in the steering column

1. Disconnect the negative battery cable.
2. Remove the upper and lower steering column shrouds.
3. Pull the flasher from the back of the multi-function switch.
   

1. Install a new flasher in the multi-function switch.
2. Install the column shrouds.
3. Connect the negative battery cable.

1. Disconnect the negative battery cable.
2. Remove the knee bolster panel from the underside of the driver's side of the instrument panel.
3. Grasp and pull the flasher from the connector located near the top of the steering column.

1. Install a new flasher in the connector.
2. Install the knee bolster panel.
3. Connect the negative battery cable.