20 Most Recent 2005 Ford Focus Questions & Answers

0helpful
1answer

2005 Ford Focus. Dashboard dead, no brake lights and blinkers.

AutoZone have some funny ideas! Problems like this are very hard to diagnose. Call out a local auto-electrician. You need someone with a pro grade scan tool and access to wiring schematics and the knowledge to use both.
4/29/2022 1:32:30 AM • 2005 Ford Focus • Answered on Apr 29, 2022
0helpful
1answer

Need to know if my

Timing belt, good for 100,000 miles before replaicng. They go to 150,000 easy and it is a freewheeling engine, no dmamge to valves or pistion if it breaks

Gerry from Ford.
11/28/2021 10:44:00 PM • 2005 Ford Focus • Answered on Nov 28, 2021
0helpful
2answers

Block heater cord on 2005 focus

I have a 2005 Ford Focus hatchback is that the same for that vehicle to my car is completely out trying to find it where it goes
6/17/2021 2:57:59 PM • 2005 Ford Focus • Answered on Jun 17, 2021
0helpful
1answer

How to do set timing on ford engine with two gear to dead

https://www.youtube.com/watch?v=fNWshnStjCc
5/17/2020 7:13:04 PM • 2005 Ford Focus • Answered on May 17, 2020
0helpful
1answer

Ford focus interior scan is deactivated

What is the interior scan deactivated
3/10/2020 12:29:59 PM • 2005 Ford Focus • Answered on Mar 10, 2020
0helpful
2answers

Where is the TCC solenoid located on a 2005 Ford focus.

Inside the transmission
10/5/2019 7:19:13 PM • 2005 Ford Focus • Answered on Oct 05, 2019
0helpful
1answer

2005 Ford Focus wouldn't start, I turn the key all the way radio works, all dash lights,No starter click or anything. Fuel pumps kicks on, replaced neutral safety switch and starter still nothing...

You have to check all fuses and relays first before you start replacing things chasing the problem and spending $$$$$$$for the wrong reason was this the same issue before you changed the neutral safety switch yes/no? That switch has to be adjusted on most cars before it will start anyway go to your battery cables check for looseness that they are clean of sulfer/battery acid /corrosion around the terminals and post and that you can not turn them by twisting now go to the power distribution box and do the same thing under the hood there's a relay there that should click when you turn the key after the cleaning check that and make sure the cable connections to the box the stud and the cables lugs are clean and shiny also the ground to the engine and those starter cables I understand everything works but that's possible because a limited amount of voltage is needed for this components to operate also this could've happened if corrosion was present you could've lost power momentarily which would sound the alarm or the horn it would've put the car into theft mode if the remote keyfob was not used to stop it you have a pats system (secure a lock) from ford with a chip key any break in power will cause your vehicle to go into theft mode and you might not have known that it happened this will give you a totally dead key no click at all as well as the neutral safety switch same thing if not adjusted properly if that applies to your car you need to have someone turn the key to start while you are moving the switch to adjust it then it will crank,and remember that obviously I'm not there so I need you to be as precise as possible in your post of (a) symptoms before you changed any parts (b) all the things you did upto now and write it all down so you don't forget to include it in the next post we will get there good luck stephen
7/25/2019 5:24:00 PM • 2005 Ford Focus • Answered on Jul 25, 2019
0helpful
2answers

The instrument cluster in my 2005 Ford Focus is completely dead except for the security system light and the door ajar light. Every other warning light and the speedometer, tach, engine temp, odomete

well bob wilson this is steve balic and i think i know you! anywho just change the instrument cluster and it be just fine! i just had same problem with my mothers 2003 ford focus and that's what it was!! i got a used one for a new one is big bucks unless u gots! u welcome bud
6/9/2019 1:11:59 PM • 2005 Ford Focus • Answered on Jun 09, 2019
0helpful
1answer

2005 focus cruise control not working

Sounds like a bad cruise control switch or a bad steering column clock spring.
1/13/2019 12:07:51 PM • 2005 Ford Focus • Answered on Jan 13, 2019
0helpful
1answer

2005 Ford Focus flasher relay control

9/29/2018 7:33:28 AM • 2005 Ford Focus • Answered on Sep 29, 2018
0helpful
3answers

Where is the fuse box in 2005 ford focus

The fuse panel is located below and to the left of the steering wheel by
the brake pedal. Remove the CD stowage box to access the fuses.
To remove a fuse, use the fuse puller tool provided on the power
distribution box cover located in the engine compartment.

Check fuse 47, it is a 20 Amp

Here is a link to your owners manual on PDF

http://www.motorcraftservice.com/pubs/content/~WO5FOC/~MUS~LEN/41/05focog4e.pdf
9/11/2018 3:53:49 PM • 2005 Ford Focus • Answered on Sep 11, 2018
0helpful
1answer

Reset code for 2005 Ford Focus keyless entry remote

So this answer is on the same topic of a 2005 Ford Focus keyless entry remote. There is no way to "reset" the code from the vehicle, however you can reprogram an existing or program a new keyless entry remote to your Ford Focus by using these simple instructions: *** THERE ARE 2 POSSIBLE PROGRAMMING PROCEDURES. ***Procedure #1 Note: Obtain all remote transmitters for this vehicle. Note: Do not depress the brake pedal during procedure.
  1. Turn ignition from OFF to RUN 8 times within 10 seconds, with the 8th time ending in RUN. Door locks will cycle to confirm programming mode. (Off is the position where you can remove your key, RUN is the position just shy of starting your car.)
  2. Within 20 seconds press any button on the first keyless remote to be programmed. Door locks will cycle to confirm programming. If you only have one remote then skip to step 4.
  3. Within 20 seconds, press any button on the second keyless remote. Door locks will cycle again to confirm programming. Repeat step 3. For all other remotes.
  4. Turn ignition to OFF. Locks will again cycle to indicate end of programming mode. Procedure #2
  5. Note: Obtain all remote transmitters for this vehicle.1Fasten seat belts and close all doors.
  6. Turn ignition from OFF to RUN 4 times within 6 seconds, with the 4th time ending in RUN. (Off is the position where you can remove your key, RUN is the position just shy of starting your car.)
  7. Turn ignition to OFF. Acoustic signal will sound and system warning lamp will illuminate to confirm programming mode.
  8. Within 10 seconds, press and hold any button on the first keyless remote. Wait for acoustic sound and warning lamp to flash (confirming programming) then release button on remote. Wait 2 seconds but within 10 seconds repeat step 4. For all other remotes. If you only have one remote then continue to step 5.
  9. Turn ignition to Crank or wait 10 seconds to end programming mode.
8/4/2018 5:51:09 PM • 2005 Ford Focus • Answered on Aug 04, 2018
0helpful
1answer

05 Focus 2.0 zx4 rear hub nut size?

29mm, torque to 175 foot pounds on assembly
6/29/2018 9:13:35 PM • 2005 Ford Focus • Answered on Jun 29, 2018
0helpful
1answer

Ford Keyless Entry Remote Programming Instructions

For most Ford vehicles you can self-program the remote for keyless entry. However there are some of the newer models that require professional equipment to program the keyless entry remote. You can check out what vehicles have self programming and which ones need professional programming here: https://www.keylessentryremotefob.com/Key-Fob-Programming-Instructions-s/1856.htm In the meantime here are the most common Ford Keyless Entry Remote programming instructions: *** THERE ARE 2 POSSIBLE PROGRAMMING PROCEDURES. ***Procedure #1Note: Obtain all remote transmitters for this vehicle. Note: Do not depress the brake pedal during procedure.
  1. Turn ignition from OFF to RUN 8 times within 10 seconds, with the 8th time ending in RUN. Door locks will cycle to confirm programming mode. (Off is the position where you can remove your key, RUN is the position just shy of starting your car.)
  2. Within 20 seconds press any button on the first keyless remote to be programmed. Door locks will cycle to confirm programming. If you only have one remote then skip to step 4.
  3. Within 20 seconds, press any button on the second keyless remote. Door locks will cycle again to confirm programming. Repeat step 3. For all other remotes.
  4. Turn ignition to OFF. Locks will again cycle to indicate end of programming mode. Procedure #2Note: Obtain all remote transmitters for this vehicle.
  5. Fasten seat belts and close all doors.
  6. Turn ignition from OFF to RUN 4 times within 6 seconds, with the 4th time ending in RUN. (Off is the position where you can remove your key, RUN is the position just shy of starting your car.)
  7. Turn ignition to OFF. Acoustic signal will sound and system warning lamp will illuminate to confirm programming mode.
  8. Within 10 seconds, press and hold any button on the first keyless remote. Wait for acoustic sound and warning lamp to flash (confirming programming) then release button on remote. Wait 2 seconds but within 10 seconds repeat step 4. For all other remotes. If you only have one remote then continue to step 5.
  9. Turn ignition to Crank or wait 10 seconds to end programming mode.
6/26/2018 1:43:30 PM • 2005 Ford Focus • Answered on Jun 26, 2018
0helpful
2answers

Why does engine die right after starting, then you wait 10 minutes and starts and runs good.

check your crank and cam sensors...see if one is not plugged tight in
3/21/2018 3:24:57 AM • 2005 Ford Focus • Answered on Mar 21, 2018
0helpful
2answers

2005 ford focus obd ll not connecting with smog computer

Check for loose pins or backed out pins in the OBD diagnostic port.
2/2/2018 11:58:57 PM • 2005 Ford Focus • Answered on Feb 02, 2018
Not finding what you are looking for?

1,815 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2000 Ford Focus
2000 Ford Focus

3,730 Questions

2001 Ford Focus
2001 Ford Focus

2,611 Questions

2003 Ford Focus
2003 Ford Focus

2,051 Questions

2004 Ford Focus
2004 Ford Focus

891 Questions

2006 Ford Focus
2006 Ford Focus

837 Questions

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85240 Answers

gerry bissi

Level 3 Expert

4390 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8991 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Focus Ford

  • Focus Ford

Most Popular Question

dashboard dead no brake lights

  • Cars & Trucks
Loading...