My1980 ford f150inline 6 wont run just trun oververy good

Try you tube !

01 ford 3.8 locked up wont trun over at all

i would start with the spark plugs

Do you check the battery??? If the battery is fine, it seems you have a bad alternator.

Key programmer X100

01 ford/ 3.8 engine locked up wont trun over at all

There should be 8 cuts total on the key. While the door and the ignition share some of the same cuts you cannot get all the cuts from one cylinder. I believe that the door cylinder only uses 6 cuts and the ignition cylinder uses 7 cuts. The cut closest to the head of the key is #1 and the cut closest to the tip is #8. If I remember correctly the ignition cylinder uses cuts 1 - 7 and the door cylinder uses cuts 3 - 8.If the locksmith cannot decode the ignition cylinder you can try to contact you local ford dealer and see if they can find a key code and cut a key from that otherwise you may have to replace your ignition cylinder.

check the wires running to the fuse box under the hood on the left side to see if the have been burning

DOSE THE TRUCK TRUN OVER IF SO CHECK FOR SPARK IF NO SPARK IT COULD BE EGNITION MODULE I NEED TO KNOW IF IT TRUNS OVER

If cooling fans are running then the PCM is not powering up. Check or replace the PCM relay in the under hood fuse panel

CHECK THE FUSIBLE LINK THAT COMES OFF THE STARTER POST.THEY LOOK JUST LIKE A WIRE, BUT THEY GET STRECHY WHEN THERE'RE BLOWN.IF THIS IS THE CASE YOU WILL NEED TO FIND THE CIRCUT THAT CAUSED IT TO BLOW,AND REPLACE THE LINK.