Vibration on 2010 f350

Ned C Cook

• 3433 Answers
• Posted on Sep 24, 2009

SOURCE: 1995 Ford Crown Victoria - shakes/vibrates @ highway speeds.

Alignment has alot to do with the tires not shimmying.. Like zero toe setting. Loose componants like tie rod ends and the idler ar worn. You can ck for excess front end play by holding the front and back of the wheel and pushing and pulling on it, like rocking it. OR have someone rock the steering while you watch where the play is from underneath. By rocking I mean turn the steering wheel back and forth. Look at all th joints and pivot points for excess play, which is, movement not immediate to the rest of the steering system. Tire balance is very important. Wheel hop is a sign of a bad tire and it overtaxes the shock absorber. Shocks don't cause shimmy because they are a vertical movement controlA shimmy is lateral or side to side.Wheel balance weights must be spit. If a 2 oz. weight is needed to balance the tire, Oe once should be on the inside of the wheel and one ounce on the outside directly across from each outher.. Loose wheel brgs will cause shimmy, but they would not last long. Caster setting on the wheel alignment will also cause shimmy. Like on a shopping car. too much caster causes the wheel to start fluttering and is very hard on other componants. This may be why you have worn tie rod ends and a bad pitman arm. Worn control arm bushings and ball joints directly affect titre wear and can only be feltwhen the front end hits a dip and detected by side wear on the tire edges. Summary: replace the tie rod end and have the car aligned. Good Luck, -Ned_ sorry about the book

SOURCE: vibration in rear of truck consistant @ 100 kmh,

Inner axle bearings checked lately too?

SOURCE: Ford Focus vibration from the front end 50-70mph

Had exactly same problem except on overrun at any speed the vibration stopped. It was the driver side drive shaft. the only evidence was about 1mm of side movement in the joint. No other tale tale signs eg knocking on turning. If you change it yourself I paid £97 and changed it in an hour.

SOURCE: 2000 ford exploorer v-8 awd eddie bauer edition

Hello, I see you may a lot of changes and replaced a lot of parts. We leased an Explorer the same Year as yours. In our case there was a slight noise as well as vibration. The problem was the Front Hub bearings, They were bad at 18000 miles.

There are a few things I want to suggest. The spinning of the wheels on the lift will not load the bearings. A Dyno table can get everything turning with a load on it. As your vehicle is a 4x4, most Dyno's were 2 wheelers. You would have to call to find one for a 4x4.

Next, if the new Hubs do not help, have a look at the rotors. They are also balanced. You can spin balance the Wheel and rotor as a unit with a floor motor. It's not the best way to Balance because tire rotation or even shifting the Wheel on the lugs will UNbalance it. But this method CAN pinpoint a problem if a Balanced tire does not spin true when bolted to the vehicle. You will know the Rotor is off-balance and which axle is causing the problem.

Would be interested to see a Post of what you found.