20 Most Recent
1999 Jeep Cherokee 4WD - Page 3 Questions & Answers
Automatic trans will not shift from 1st to 2nd on 1999 Jeep Grand cherokee
HelloThe
Engine and Automatic Transmission (not applicable to manual
transmissions) in this vehicles drive train are fully
electronically controlled by a computer called the PCM and TCM (Power
Train Control Module, Transmission Control Module). When a problem
like this or other drive-ability related problems occurs the computer
stores a record of the problem (there are of course some exceptions
to this, like the fuel pump, engine coolant temperature sensor and
MAF sensor for instance) in the form of a fault code in its memory,
to read these fault codes you must have the systems memory scanned
with a special tool. Once the fault code(s) are read you then must
perform the appropriate diagnostic testing to find and resolve the
problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED
TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD
EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM. Also always
check fuel pressure for correct spec for your make and engine type.
9/12/2012 10:00:06 PM •
1999 Jeep...
•
Answered
on Sep 12, 2012
Squeeky when turn
sound like the bushings are bad or loose check the tortion bar bushings and pins. or the axel boots
2/21/2012 12:47:15 AM •
1999 Jeep...
•
Answered
on Feb 21, 2012
Diagram location for a flasher box for a 1999 jeep cherokee
The relay is above the fuse box accessed on the drivers side above the drivers feet. The relay is in the third receptacle from the left on top of the block. A relay costa from $17 up. if your handy with a solder iron when you get the relay out pop the cover off with a small screwdriver. get a magnifying glass and check the solder joints. Usually they crack from the heat stress. Just resolder joints if you find one cracked. and you should be ready to go. If no joints are cracked then its time for a new relay. I just replaced one on a 98 ram pickup owner said just replace it. so i did.
12/30/2011 9:11:08 PM •
1999 Jeep...
•
Answered
on Dec 30, 2011
What is code po700
check the input and output speed sensors for failure,or of different voltages,and or replace both of them at the same time.
12/13/2011 6:09:19 AM •
1999 Jeep...
•
Answered
on Dec 13, 2011
Not finding what you are looking for?