20 Most Recent 2000 Jeep Cherokee Questions & Answers

0helpful
2answers

I have a 2000 Cherokee Sport that the AC was not

what type of guage were you using. the low pressure cant take up to 100 psi... it would have burst if it had gotten that high. I have seen this happen before. It sounds like the high presure filter is bad or the dryer is bad. If you can do the work yourself its not that expensive.
7/8/2020 10:48:53 PM • 2000 Jeep... • Answered on Jul 08, 2020
0helpful
1answer

Keyless remote entry problems cherokee sport

I have a few trouble shooting things you can do. These should be taken only if your keyless entry remote was working at some point and then stopped working. 1) Wipe the board The board inside your remote can get a lot more filthy than you think! When the board is dirty it can prohibit the contact to the circuit board when you push down on the button. Simply wiping the circuit board off can make your key fob like new again! 2) The old car battery reset trick I know this sounds absurd, but it works sometimes and is worth trying. If you exhausted all of the options above, disconnect bot terminals on your car battery for 10 minutes. Then reconnect them and try your key fob. This has worked for many people and I have no idea why. If you do, please comment below to explain. 3) New fob! It might be time for a new key fob! No need to dread over the expensive costs of a new key fob, at Keyless Entry Remote Fob Inc., you can get a refurbished one for a very affordable price! You won't even be able to tell the difference. Just search your vehicle make, model, and year to find your key fob or give us a call at 402-671-5100.
7/21/2018 4:24:18 PM • 2000 Jeep... • Answered on Jul 21, 2018
0helpful
1answer

My 2000 jeep grand cherokee laredo won't stay charged

Trouble shooting required: What voltage is do you get with a multi meter at the battery terminals when the vehicle is running. (looking to see the alternator is putting out the required voltage) What voltage when it is not running & during cranking. (testing the quality of the battery) Does the battery go flat overnight? What if you disconnect the battery overnight? (Looking to see if something is draining the battery when the vehicle is not running)
1/20/2018 12:35:34 PM • 2000 Jeep... • Answered on Jan 20, 2018
0helpful
1answer

Jeep Cherokee Sport 2.5 D

By power washing it you probably have water in the electrics and the electronics!! Take the Jeep to a good auto electrician and he might be able to tell you where the problem is. At least then you'll know where to start looking. THIS is what happens when you pressure wash modern engines!!
1/12/2018 3:18:10 PM • 2000 Jeep... • Answered on Jan 12, 2018
0helpful
1answer

2000 Jeep Cherokee A/C not blowing cold,

test compressor unit to make the clutch magnet is to make sure its engaging. Youtube it or google it and you'll be surprised what you find. It can be a DIY if your handy that way. And a lot less expensive as there are replacement parts for these.
11/24/2017 4:06:00 AM • 2000 Jeep... • Answered on Nov 24, 2017
0helpful
1answer

2004 jeep grand cherokee laredo, po162, po123

It is most likely the TPS sensor for the P0123 code(TPS voltage out of range). If P0123 occurs again, repair. The P0162 may be a result of the P0123 failure. So repairing the P0123 may also correct the P0162 fault. The P0162 appears to be Jeep enginr specific. The following link may be of help. P0162 DTC For Mitsubishi Jeep
6/18/2017 9:00:08 AM • 2000 Jeep... • Answered on Jun 18, 2017
0helpful
1answer

2000 Jeep Cherokee Sport heating & a/c problem.

If your saying the blower runs intermittently, I'd start testing at the blower motor when problem is ongoing, if good voltage and ground with no blower action, suspect the blower motor. Did you use a test light to check voltage at fuses, as you can see, one fuse goes hot with the key on, the other fuse is hot all the time. The top wire in diagram for blower motor is voltage, the bottom wire is ground. Any motor that uses brushes and the brushes are worn badly, the motor may run intermittently. blower motor-oj0xa20ymx22hml3q4c1tsye-3-0.jpg
6/16/2017 7:46:45 PM • 2000 Jeep... • Answered on Jun 16, 2017
0helpful
1answer

Engine will only run if gas pedal is pressed all the way

the battery is dead, you know that. (and may be bad) why, is the only issue. if lucky just its no good, now, the love to go totally dead after being totally discharged, like that. we use charger to see if it has hope, if not a new battery now. when started was the charge /battery lamp off? why not take the battery to walfart and exhange it. for new. take it home and now it starts. then see if the battery works and holds charge, charge lamp in cluster out. or use voltmeter see 13.3. to 15vdc, normal alternator power. a bad battery (shorted) can cause the altenator to shut down so, only good battery there is best practices, or go crazy. right now,im trying to bet my boat trolling battery back to life. but is hopeless...... if you had a battery charger in your shop you;'d already know, battery good/bad.
3/26/2017 12:53:17 PM • 2000 Jeep... • Answered on Mar 26, 2017
0helpful
1answer

How to replace a antenna for a 2000 grand jeep laredo

same as allcarsunbolt it, remove it.is car in USA,some cars have electric motor up/down antennas.if USA ,the manual is free to read, posted over 300 timessearch much.?2000 Grand Cherokee, is name, WJ jeepsee AUDIO chapterhere ,its there, under WJhttp://www.morris4x4center.com/knowledge-base/index.htm?utm_source=cj#service
2/13/2017 1:01:20 PM • 2000 Jeep... • Answered on Feb 13, 2017
0helpful
1answer

..Fusible Link What gauge wire do I need to use for the main fusible link in a 2000 jeep cherokee?

my guess he means , what thermal wire code to use. they are color coded. the fuse is bottom M1/M2 location of the PDC right"? the problem is the OP failed to show exact wire. my guess this is PDC question, (where are your hands/?) fuse link A11? gas engine, right, USA? A11 code 10 DG (dark green) to the generator? caused by shorted ALT or changing it with battery connected yes, they blow. the they have not just one engine, nor one alternator but 124 amps the alt on 4L , with automatic. 4speed. these are the rules. SAE.ORG What size replacement fusible link should be used ? The automotive service industry recommends using the same gauge and length as the blown fusible link after the cause of failure is corrected. guide lines, A 14-gauge wire would be protected by an 18-gauge fusible link. A 6-gauge wire would be protected by a 10-gauge link, and so on. Odd number wire gauge sizes like 19, 15, 13 and 11 are counted when sizing a link. The length of a fusible link should not exceed 9". is the old link, still readable. see the color measure its size,. these tow question are first. my jeep FSM shows it as 10 gage harness size. (M1/M2 gen slot) so, 8 gauge thermal link is my guess. per SAE. why not go to jeep and buy it?
1/5/2017 1:01:04 PM • 2000 Jeep... • Answered on Jan 05, 2017
0helpful
1answer

I have a 2000 jeep cherokee hood wont open

Have someone pull the latch and while you bounce yourself off the hood , and it should open !
11/7/2016 8:04:42 PM • 2000 Jeep... • Answered on Nov 07, 2016
0helpful
1answer

How do you remove the headrest on a 2000 Jeep Cherokee

factory service manual 2000. I posted the book free here 300 times. as they say RTM , read the manual>? Ill quote the pages for you . "REMOVAL AND INSTALLATION HEAD RESTRAINT SLEEVE REMOVAL NOTE: When replacing a head restraint sleeve, the retaining tabs on the sleeve will be damaged during the removal process. Check the availability of replacement parts before servicing. (1) Raise head restraint to the full up position. (2) Turn head restraint lock thumbwheel to release head restraint and pull head restraint upward to remove from seat back. (3) Insert head restraint sleeve extractor (special tool 6773) (Fig. 1) and (Fig. 2) into the seat back. (4) The retaining tabs are positioned on each side of the sleeve, when inserting the extractor, ensure that the flat of the collar is facing the side of the seatback (Fig. 3). (5) Using a small hammer, tap extractor downward to release sleeve retaining tab. (6) Remove extractor tool from sleeve, rotate tool 180 degrees (Fig. 4) and repeat steps 3 and 4. (7) Remove extractor tool from sleeve and remove sleeve from seat back." 26297855-cv3cea42xo3hns4wc2h2eyux-1-0.jpg
10/21/2016 12:30:05 PM • 2000 Jeep... • Answered on Oct 21, 2016
0helpful
3answers

AC Cold air but no volumne of air flow

Please check for any blockage and in the ac duct, IF the duct is clean you need to refill the AC gas and get it serviced as the AC thens to weak over the years ........................







good luck................
3/15/2016 1:28:21 AM • 2000 Jeep... • Answered on Mar 15, 2016
0helpful
1answer

Where does the return line connect to on the gear box?

RTM yet? XJ jeep, guess not here it is . posted over 100 times. http://www.morris4x4center.com/knowledge-base/index.htm?utm_source=cj#service
12/26/2015 4:42:36 PM • 2000 Jeep... • Answered on Dec 26, 2015
Not finding what you are looking for?
2000 Jeep Cherokee Logo

902 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6928 Answers

Greg Bernett
Greg Bernett

Level 3 Expert

2993 Answers

Mike

Level 3 Expert

4377 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Cherokee Jeep

  • Cherokee Jeep

Most Popular Question

sentry key light 2000 jeep cherokee

  • Cars & Trucks
Loading...