Question about Elite 45986 Front Load Washer
...number for the sensor. I did, however, watch the tech replace it. A very simple 5 minute procedure. ? First, remove the three screws holding the module in place ? Second, there is a wire retaining ...
...set the number of rings of the fax one time higher so that your anwering machine can pick up the phone. You should set the fax to tel priority. after that i still had a problem which was due to the ...
...number so I cannot use at the moment. You need to get a hold of a service tech to do it. It is an NCU parameter. If it isn't set properly, unpredictable results can happen to the machine. This ...
Question about FaxCentre F116 Plain Paper Laser
...number the phone rings.. ? The machine, however, does not pick up the fax. I was looking thought the menus/manual for an auto answer type of setting but i have had no joy? Any Ideas? If this is on a ...
Question about WorkCentre Pro 635 Laser Printer
NOTE: When the machine is set to Auto answer and the set number of rings occurs, the machine answers with a fax signal tone and enters the Auto Receive mode. Press [Stop] to return to the Standby mode
...rings once for most incoming calls but for faxing purposes I have a second number on the same line that has a double ring to it. How do I get the B2540 to only answer the fax machine on the double ...
Question about OfficeJet J4580 All-In-One Laser Printer
...set up, but it won't answer the phone to receive the fax. It's a HPj4580 officejet all in one. Thanks for any help you can offer. I'm a phone/data field service tech so all I can tell you is the most ...
Question about Officejet Pro 8500 Wireless All-In-One InkJet Printer
...set it to off then go to basic fax setup then check the rings to answer please make sure that the rings to answer for fax should always be 2 rings more than the telephonic answering machine run a fax ...
...number of rings (see set rings to answer on page 12), then switches to FAX receiving. TEL answer mode If the answer Mode is set to TEL, you must manually receive faxes. 1 Answer the telephone. 2 If ...
Question about Officejet 6700 Premium E-All-In-One
number of rings to answer from 2, to 3 to 4 to 5, nothing works. I have restored all factory settings, no help. I have changed the telephone line to the two wire specified, no help. My machine USED TO
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions