Question about Aquarius WD640 Front Load Washer/Dryer
bit about washing machines you will probably find that your heating element from the dryer has stopped working. If you can still wash clothes that means that your other heating element for the washing
...FIT AN HEATER DRYER ELEMENT THANX dry heater is located under an aluminium housing on top of the machine. take it to bits and easy to fit. however, why do you need a heater? if no heat on dry, cause ...
...Spot) which does not reset, the component must be replaced. It is not a simple DIY task as it is fitted from the INSIDE of the air heater duct. In my case, there were signs of burnt fluff in the ...
...and unclog it. u have 2 do this frequently if u live in a hard water area. mine does this 2 !!!! its easy 2 sort but a bit of a pain as u need a shallow tray 2 fit under 4 the water. hope this
Question about Aquarius WD63 Front Load Washer/Dryer
Dismantling door of Aquarius 1100 WM63P. Need to fit a new door hinge and two new parts of the inge bearinng kit (bits with holes for hinge pins). Can't get these old hinge bearing lugs out and think ...
...Fit back in reverse order, and make sure the hose is on properly. Plz rate my solution.Thanks. The filter is a grey piece of plastic which is tube shaped and has holes in it . It can be found in ...
...fit the washing machine door seal to my zanussi washer dryer. Any tips?? Its a tricky one but the easiest way is tolubricate the inside of the flap with wash up liquid then starting at bottom feed it ...
Question about Aquarius WD640 Front Load Washer/Dryer
...is not spinning or emptying Above machine is approx 5 years old and has not been used for 2 years. Fitted it last night and turned on to check it works and clean it and it will not spin or empty... ...
bit short once I loop it around the drum... Are there any instructions on how to replace the belt online? There does not seem to be a tensioner on the pulley which would facilitate the installation...
fit them back together as when I put them on, the knob will not stay in place, the yellow plastic bit will but the rest won't and I have no idea where the spring comes into the party!! Can anyone help
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions