Bosch Nexxt 300 series WFMC2201UC has no water coming in. I have replaced the inlet valves, cleared all screens in hoses and still no water. It seems there is no power to the inlet valves. Is there a way to check and if no power what next.

Possible that the drain pump is running due to a small leak is present at the base of the machine, providing this has a metal cover on it ,it gets water in here which activates afloat switch switching on the pump hence draining the machine to avoid possible flooding, if the pump does not appear to be running then the drain hose is too low resulting in syphon effect,in which case raise it...Good luck

Check hot water hose / valve filter. Check hot water inlet valve with multimetre.

turn off THE POWER by c. breaker, wait by 45 seconds, and turn ON again and try it.
God bless you

please download the user manual from the manufactures website its normally free and look at the trouble shooting guide for help on the subject eric

Possible that the inlet vavle is choked with dirt and should be cleaned. when the machine is switched on there must be free flow or else the filter in the inlet is dirty which can be removed and cleaned,
Also choose a different cycle to vary the timing of the wash.

I will assume the noise is happening when you have water coming inot the machine.There may be a chance the water pressure is to high.you may also need to replace the water inlet valves.

the valve is not working, it is not opening to allow the water through, easy to get hold of and not that difficult to fix, the valve is the part of the machine the cold hose screws onto

under loaded fill it up

The machine will only take water from the hot tap when it is set to a 95degree wash, it will heat the water on all other cycles itself. apparently an energy saving feature.

Make absolutely sure you have the hoses connected to the correct inlet valves,it sounds to me as though they are the wrong way round.
Plz rate my solution.
Thanks.