I cannot get my control board to clear. I receive

E1, F1 are Error Codes indicating a Control Board Failure, and normally time to buy a new stove.

https://www.google.com/search?q=Kenmore+stove+95004102+E1%2C+F1+error

LOC

How to Clear the Oven Lock Mechanism on a Kenmore Stove

https://homeguides.sfgate.com > ... > Home Improvement
Clear the lock mechanism -- as indicated by the DOOR LOC light -- by pressing and holding in the oven door light switch for 20 to 30 seconds. While the switch ...

Hello Annie, thank you for allowing me to assist you!

I see you are still receiving error code "LOC" even after replacing the door lock assembly. Let's try unplugging your washer once again to determine if it is a false error code. It is important to wait roughly ten minutes and then turn your washer on. Before selecting a cycle, press OPTIONS and SELECT at the same time for 20 seconds until "LOC" is no longer displayed. If the error code does not clear, then your washer more than likely may be experiencing an issue with the control board or wiring harness. I hope this information helps to some degree.

Hello

LOC error code is displayed when the control panel is locked, to unlock it press the OPTION & SELECT button and hold them for 20 seconds. This should reset the control, if it does not then replacing the control is recommended repair. Please get back to me if you have any other questions.

Kevin

HI. The term"LOC" will be an indication of the "Child Locking" feature that has been activated either by mistake or intentionally. This is a safety feature to prevent unwanted starts when children are present.

To unlock the controls,press "Options and Select" at the same time and hold for 10 seconds until ”LOC” is no longer displayed.

• NOTE_ If the release procedure doesn't unlock the unit and the letters LOC continue to appear, this will be a strong indication of a severe fault within the main control board. try to power cycle the unit if this is the case. if the power cycling doesn't produce good results, replace the main control board assembly.

The LOC code merely means the control responded and locked the door. You'll find a tech sheet under the top panel of the machine to help guide you thru the diagnostic process, which is fairly involved.

LOC means it thinks the control panel is locked. This gives the ERR indication when you push the buttons. To unlock it you need to hold down the Options and Select buttons together until it reacts.

I know this may seem silly but - On the top right back corner of your washer hit it with medium force with your fist, this helps.


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

Your door lock switch needs replacing.

You can try clearing the code and then running the machine. Try colding down the pause and clear button simultaneously for three second s and the faul should clear Or try turning the knob around 9 times to clear the fault.

The LOC code merely means the control responded and locked the door. You'll find a tech sheet under the top panel of the machine to help guide you thru the diagnostic process, which is fairly involved.

LOC means it thinks the control panel is locked. This gives the ERR indication when you push the buttons. To unlock it you need to hold down the Options and Select buttons together until it reacts.

I know this may seem silly but - On the top right back corner of your washer hit it with medium force with your fist, this helps.


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

That is a control locked sign you need to relase the Child lock from the control panel and this should be in your manual if not go to their website and you can download the use and care guide

The control panel may in *LOCKED* mode. Press the *OPTIONS* and *SELECT* buttons at the same time and hold for about three seconds to unlock the control panel. Make sure the detergent tray is fully closed too.