20 Most Recent Electrolux EW1000i Front Load Washer Questions & Answers


How much trouble do you want to go to?

If you just want to preserve the washing, then simply put it on another cycle tonight and that will keep it fresh until the callout turns up to fix it.

The next clever step is to power the machine off at the mains for 10 minutes. Depriving it of power MAY release the interlock door switch even if the cycle didnt.

Final attempt to get to it... Turn off power, unplug at the mains. drag the machine out so you can see the back. Remove the 2 screws that hold the top on, pull back or tap the top forward (depending on the model) to unclip it. Peer inside. You will see the door switch inside the chassis exactly in line with the door handle on the outside. See if you manually make the mechanism release, or if you have a stubby philips screwdriver, you can probably unscrew the switch complely.

If you trust yourself NEVER to open the door in the middle of a cycle, the machine will of course function without a switch. Just so long as you recognise that you will flood the place if you do open it with water in. Also if you put your hand inside dirung a wash (Or worse still a spin) the power of the motor combined with the weight of the wet washing will rip the arm clean off a fully grown man, so if you doubt yourself or you have kids (or kids may visit) don't leave it like this.

Electrolux... | Answered on Mar 24, 2019


disconnect from electricity. take back panel off.you will see heater at bottom of tub held in by 1 10mm nut.disconnect wires to it. loosen this nut and pull heater out - you may have to help it with a screwdriver. you can then see into the gap between tub and drum and fish for the bra wire.
tell her not to wear bras with wires!!

Electrolux... | Answered on Jan 22, 2019


I have touchscreen! Doesnt work. Any suggestions? Hate having to get up middle of night to turn off this )%(/₪/#&/₪(" beep!

Electrolux... | Answered on Sep 23, 2018


When the washing machine is turned on... it beeps and displays error message E90 it wont operate.

what can i do ?

Electrolux... | Answered on Jul 04, 2018


In case of error in the mains, or like what happend today at my house, the power lines went partially down, providing too low voltage, EH0 or EH1 will occour. If you also notice that the lightning indoor is somewhat dimmed during this error, the voltage is too low.

Electrolux... | Answered on Oct 22, 2017


you need to hold the option and extra rinse buttons simultaneously for 6 seconds...you will see the padlock symbol go and then use your machine as usual

Electrolux... | Answered on Jun 19, 2017


Fualty out of balance switch or front door lock.

Electrolux... | Answered on Oct 31, 2016


they are self cleaning normally when you wash a load of cloths .

Electrolux... | Answered on Jan 24, 2016


First of all check filters in hoses & water valves, if ok then water inlet valve may be burnt out. Unplug power cord, remove top panel panel, check where 2 wires go to each water valve & check that area on valves for burning. If burnt or smells of burning, replace valve. IN SOME INSTANCES A COMPONENT BURN OUT CAN CAUSE DAMAGE TO CONTROL BOARD.

Electrolux... | Answered on Apr 28, 2015


E90 is family error code visible to the customers. It is necessary to read the error in the service mode so please proceed with the following procedure for rapid reading of alarm codes:
Press and hold down START/PAUSE and the option button nearest to the START/PAUSE button for at least two seconds!
After that the display will show one of the following errors that are more precise:
E91, E92 - Communication incongruence between main board and display board (versions not compatible). Posible causes: wirings, main board or control/disply board.
E93 - Incorrect configuration of appliance. Posible causes: Incorrect configuration data; electronic board faulty.
E94 - Incorrect configuration of washing cycle.
Posible causes: Incorrect configuration data; electronic board faulty.
E95 - Communication error between microprocessor and
EEPROM. Posible causes: Electronic board faulty.
E97 - Incongruence between programme selector and
cycle configuration. Posible causes: Faulty electronic board (Wrong configuration data).
Considering that this is a complicated fault, my advice is to contact an authorized service center.They have special equipment such as an interface that allows them to upgrade software in your appliance. If you are not doing anything on the appliance before the failure, the only thing you can check is the contacts between wiring and electronics.

Dado

Electrolux... | Answered on Feb 14, 2015


Program the machine for white wash and turn down temperature and duration manually, and tune up the sentrifuge program to maximum RPM.

It helps to use a machine with large drum and minimum 1600 RPM. Large diameter of the drum is more efficient than a small diameter drum at the same RPM.

Electrolux... | Answered on Feb 04, 2015


Machine tries to drain for 10 min (timeout) without emptying the tub.
Possible fault:
- drain pump
- drain filter
- drain hose
- wiring between drain pump and electronic
- electronic

Dado

Electrolux... | Answered on Jan 06, 2015


Thank you for your inquiry, cheryl!

I understand that you have removed your soap dispenser on your Electrolux washer and are having a challenge getting it back into place. It should go back into place once lined up. If you continue you having an issue I would suggest having a professional technician out to your home for proper install of the dispenser. Good luck. -Matt

Electrolux... | Answered on Dec 19, 2014

Not finding what you are looking for?
Electrolux EW1000i Front Load Washer Logo

440 questions posted

Ask a Question

Usually answered in minutes!

Top Electrolux Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1479 Answers

jimorris77

Level 3 Expert

411 Answers

Brad Brown

Level 3 Expert

18060 Answers

Are you an Electrolux Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Electrolux Washing Machines

  • Electrolux Washing Machines

Most Popular Question

front load washing machine working but

  • Washing Machines
Loading...