I want my ditto tv password - Televison & Video

Check for the obvious - tv plugged in? power at receptacle? Fuse blown on power supply? Swollen, leaky caps or burnt resistors, open diodes on power supply?

Otherwise, you have a problem on one of your boards. Enter the exact symptoms on Google and you will get all sorts of blogs indicating where the source of the problem might be. Ditto for Utube.

Fault with the main power supply regulator board. Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts.
http://electronicshelponline.blogspot.com/
It will be best to replace the power supply regulator board as card basis rather than making "Surgery" to it; which usually will make loss for both money and time.

these drives are so old, even I don't have the software. If I should haven I can't read it, because I done have any floppy disk connected to any computer. But if you really want the drive to run, why not try a program from Novastor. Or connect them, to check your drive is still supported. But first make sure your computer can connect the drive. Because newer computers don't have floppy connectors nor SCSI interfaces.

Backup Software for Home Users and Small Businesses the drive.

Did you do the installation required for the system to recognize the added hard drive, it is not plug and play.

ditto tv not dowanload

Is it possible to find an old computer running an old version of Windows, and then to connect the tape-drive to that computer, and then to copy the files onto a folder on that computer?

Then, if that computer has a network-card, you can "share" that folder, so that all computers on your network can then access that "shared" folder, i.e., to copy the files, and then to burn them to a CD-recordable.

To setup Google as your home page try the below steps
1. Go to control panel 2. Internet options 3. under general tab / Homepage 4. type in http://www.google.co.in/ 5. click on apply & ok
Google would be setup as your default when you open Internet explorer

Do you expect TV audio to go TOWARD the receiver in this setup? The HDMI is to get video and audio TO the TV. The BEST TV-related audio will come from the device supplying it, not the TV.

Try this. Take the digital audio from the cable / satellite box into the receiver. Ditto for games or whatever.

After all, what else enters the TV that isn't already connected directly to the receiver?

Closed captioning can come trough 4 sources 3 of them access a digital file and display it to the screen. ALL must be set to off on each device:
Embeded in actual program video source--unlikely your problem.
TV decoder cotrolled by TV menu under "language"
Cable box--ditto for menu selection
DVD player or VHS tuner--Ditto for menu

ditto bad flyback