System Error Cycle Power

Fully disconnect from power, push power button several times to discharge.
Wait 30 minutes, plug it back in. Try again.

you have a plugged or partial plugged drain pump for sure. maybe there is a 20 stuck in it this time! easy to find just follow the drain hose back and you will find your pump.
also could be the cycle your using has a bad area in timing cct. check a different cycle like the delicate cycle and that will confirm pump or cycle

Check for a Paper jamb

Hi
Pump-out not accomplished in normal time.
Check the drainage and replace or reposition the drain hose,Clean it out by running the disposer.

I suspect your lid switch is broken:

Video:


More here

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

When you cycled the power, did you just push the power button?

If so, to really do a power cycle you need to unplug, let sit off for 30 seconds, then plug back in.

> CYCLE POWER

Turn the printer off.
Disconnect the power-cable from the wall-outlet.
Reconnect the power-cable.
Turn the printer on.

This is the full "cycle" from ON to OFF to ON.

System error --> software inside the printer has detected some sort of "software" error.

Cycle power -> disconnect the AC power.
Wait a few seconds.
Reconnect the AC power.
Turn the printer on.

The code is UE

load too small.
• Load is out of balance.
• The washer has an imbalance
detection and correction
system. If individual heavy
articles are loaded (bath
mat, bath robe, etc.) and the
imbalance is too great, the
washer will make several
attempts to restart the spin
cycle. If an imbalance is still
detected, the washer will stop
and the error code will be
displayed.
• Add 1 or 2 similar items to help balance the load.
• Rearrange items to help balance the load.


please rate this help to keep the service online

Hello grumpy 96
Welcome,

You said, the control panel stays lit after cycle ends. it won't shut off and beeps several times during cycle

First try Pressing STOP/CANCEL to clear the display.
If this does not do the trick.

Sounds like we need to try to reset the system!

Huuum At your service!
Lets try this,
Like with an error code.
This can reset the system if it is electronic!
Unplug the appliance and wait a 5 minutes then restart it.
If you can't reach the plug, use the breaker to cut the power for 5 minutes.

It's like rebooting your computer when its acting strange!
Usually it corrects some error problems if they are not serious.
Or they are sometimes just a glitch.

Let me know how it works!
Waiting for your reply!

Please remember to leave a rating when you are done!
Thank You
Huuum





Please remember to leave a rating before you go!
Thank you