How to reset E33 xerox machine - Lexmark E330 Laser Printer

1) You have to buy the new drum from the trusted seller and have to install the same into your machine.

2) The standard method of resetting the printer machine would be, unplugging it from the socket and removing all the cables from the machine.

3) Disconnecting all the established connections. Evacuate the old drum out of the machine and insert the new drum into the slot.

4) Pressing the reset button would reset the Xerox machine. After inserting the new drum, reconnect the cables and establish the removed connections.

5) Turn on the Xerox Workcenter 3615 and check if it is working properly.

I suggest that you search online for "error code e33 + little swan" you'll find most websites will offer some information.

Replace the toner, open and close the front door several times and let it cycle until the E33 disappears. Comes from copying even after add toner display comes on.

Hi Moataz,
E33 is low level pressure switch fault. It prevents the element over heating with a lack of water.
Check that the pressure switch operates at both the low level and high level using your multimeter.
It is also worth checking the NTC device on the heater in case it has gone down.

Hello - I am happy to assist you. However, are you certain that the error code is E33? From my research this manufacturer does not have an E33 error code for any of their units. Could it possibly be E32 or E35? If so, it is related to a pressure sensor issue. Either it has detected a pressure senor calibration error or an overfill water pressure sensor problem. Try reprogramming the unit by unplugging it or flipping the household circuit breaker off. Wait approximately ten minutes and restart washer. If it proved to be ineffective, contact a professional to properly diagnosis the unit and move forward accurately.

Try this link:

https://www.support.xerox.com/support/workcentre-c2424/support/enus.html?operatingSystem=win10x64&fileLanguage=en

E 33 means that the machine is out of toner. Please replace toner the machine will be ok.

how do I reset xerox 575 drum

E33 means that you've run out of toner. replace the toner cartridge

your copier should be displaying a fault code, different codes need different reset codes - be specific