Loads on start - Ingersoll Rand 3/4" Super Duty Extended Anvil Air Impact Wrench

Id like to see if I could help you so you will have to use more definitive terms, "Start" I'm guessing that you mean that the drum doesn't turn? (the lights come on and you push the start button and the drum does not turn) If that's the case I would start with the door switch, Best to start with the most obvious first. Try jumping it to over ride wait your response

• 1 Allow the movie to load completely, or at least halfway, before you start to watch it to stop video buffering.
  
• 2 Start the movie and then hit stop until the movie has fully or halfway loaded. As the movie is loading, you should see a yellow or gray line. The line you see will get longer as it loads.
  
• 3 Close all windows that you don't need. Having too many windows open will slow the loading process.
  
• 4 Resume play once the movie is at least halfway loaded or fully loaded. By this time, you should be able to enjoy the movie without the video buffering or constant starting and stopping.
  

Hmm I had the same problem with my pc..turned out my pc was full off dust and was over heating from the start.

hey I got the same problem for ps3, it plays everything except gta 4. The icon starts up right then i click on it and it starts to load load load and then it stops and says 80010006 error. And I got no solution to it. Do you know how to stop that error?

wait until cool down and restart. if its starts then suspect a short winding in the motor. replace if needed.

most washers if put on a large load do start going around before the water has finished filling this is just to get all the clothes fully wet before the proper cycle starts to wash them it is just how the washer copes with a large load peter

before windows starts press f8 a couple of times to get into safemode.
if windows doesn't load then you probably have to reinstall windows.
If windows does start, try going into msconfig. Go to Start - Run then type in msconfig. click on the startup tab & try to remove some of the start up programs to see if thats the problem.

REPLACING BELLOWS

Are you sure the door is closed properly? Give it an extra push. The start/pause button could also be damaged/faulty. Try switching the machine off at the wall socket and on again.