1
Anonymous posted an answer for this 1990 Ford Escort:
"rear hub is stuck"
AnonymousAnonymous posted an answer for this 1990 Ford Escort:
"hit the wheels in the center with a slege hammer"
Anonymous
Anonymous posted an answer for this 1992 Honda Accord:
"My 1992 honda accord will not engage any gear other than reverse. This happens in park,..."
AnonymousAnonymous posted an answer for this 1992 Honda Accord:
"lincage rod inside the gear box will have bent it happens when to much preasure is applied..."
Anonymous
Anonymous posted an answer for this 1998 Honda Accord:
"I have a 98 Honda Accord V-6 the check engine light is on a fails emmisions for p04010..."
AnonymousAnonymous posted an answer for this 1998 Honda Accord:
"your vacumes are blocked on the air intake"
Anonymous
Anonymous posted an answer for this 2000 Honda Odyssey:
"take apart and take out new one in and put back together"
AnonymousAnonymous posted an answer for this 2000 Honda Odyssey:
"How do I replace the front wheel bearing on 2000 Honda Odyssey EX?"
Anonymous
Anonymous posted an answer for this 2005 Honda Accord:
"take to a garage and get a diagnostics or buy a new raido i have one for sale ;-)"
AnonymousAnonymous posted an answer for this 2005 Honda Accord:
"Does anyone know of a way to retrieve the radio serial number from a 2004 Honda Accord..."
Anonymous
Anonymous posted an answer for this 2001 Honda Accord:
"maby try blocking the vacumes all off or try new carbaretors"
AnonymousAnonymous posted an answer for this 2001 Honda Accord:
"my car idols rough while in park ... could i have a vacuum leak ?"
Anonymous
Anonymous posted an answer for this 1994 Honda Accord:
"the iddle some times gos up end down on my 94 honda accord 4 cyl"
AnonymousAnonymous posted an answer for this 1994 Honda Accord:
"if its carbaretors you might need to replace them"
Anonymous
Anonymous posted an answer for this Honda Cars & Trucks:
"How do I take the front bumper off of a 98 honda civic"
AnonymousAnonymous posted an answer for this Honda Cars & Trucks:
"lift the bonnet up and infront of the bonnnet catch is a line of star screws"
Anonymous
Anonymous posted an answer for this 1997 Dodge Intrepid:
"what size wrench do you need to change out the alternator?"
AnonymousAnonymous posted an answer for this 1997 Dodge Intrepid:
"depends on which type of car but i think maby a 15 to a 17 mill"
Anonymous
Anonymous posted an answer for this 2000 Lexus RX 300:
"hi, today i discovered a scratch on the rare side panel of my new lexus rx 350 car. Don't..."
AnonymousAnonymous posted an answer for this 2000 Lexus RX 300:
"polish or t-cut"
Anonymous
Anonymous posted an answer for this 1997 kawasaki ZRX 1100:
"After riding my 2000 ZRX for about an hour it won't start back up after being off for 15..."
AnonymousAnonymous posted an answer for this 1997 kawasaki ZRX 1100:
"NEW BATTERY !!!"
Anonymous
Anonymous posted an answer for this 2005 TN'G Milano 150:
"Need serial numbers to buy parts bearings ,seals etc. from online dealers so as to save on..."
AnonymousAnonymous posted an answer for this 2005 TN'G Milano 150:
"DOCUMENTS"
Anonymous
Anonymous posted an answer for this 1990 kawasaki ZXR 750:
"my bike felt like it was holding back at about 2000 rpm, thought it was carb problem,..."
AnonymousAnonymous posted an answer for this 1990 kawasaki ZXR 750:
"there must have been dirt in your tank and has been pulled threw with the petrol at the..."
Anonymous
Anonymous posted an answer for this 1992 Yamaha TZR 250 R:
"my tzr125 2rk 1991 the bike splutters in every gear and wont go above 55 60 this is doin..."
AnonymousAnonymous posted an answer for this 1992 Yamaha TZR 250 R:
"gett a high preformance spark plug as i had the same problem with my bike"
Anonymous
Anonymous posted an answer for this 2007 Aprilia RSV 1000 R Factory:
"no just a little"
AnonymousAnonymous posted an answer for this 2007 Aprilia RSV 1000 R Factory:
"Put too much oil in my 07 aprilia rsv factory. Need to drain some off again! Does all of..."
Anonymous
Cars & Trucks 10 answers
Motorcycles 9 answers
