20 Most Recent 1997 Dodge Intrepid Questions & Answers


It sounds to me like you have a bad ground wire (common occurrence when after-market sound systems are added). Check the ground wire behind the cluster, making sure it is solidly connected to chassis.

1997 Dodge... • Answered on Oct 06, 2019


It is the V6 engine you have two sensors on the front and two at the back that way!!!

1997 Dodge... • Answered on Jun 21, 2018


Code 700 and 740 r transmission and torque converter malfunctioning. Which most likely is caused by not enough fluid do to the leak. Code 401 is a egr (exhaust gas recirculation) valve problem. Most likely it's dirty. It depends on location of leak as to wether or not you can do it yourself. If leak is from pan you can get a filter and gasket kit. Remove all bolts surround pan and remove be careful as the residual fluid needs to be captured. Remove old filter replace with new filter. Use caution and scraping old gasket off pan. Check pan rim for any distortion or dings. Put new gasket on pan replace pan on vehicle using appropriate torque and sequences for tightening of bolts

1997 Dodge... • Answered on Nov 19, 2017


Use Diagnostic Unit, you will not find your fault any other way, (ie) fitting parts that you might think will work , is costly.

1997 Dodge... • Answered on Oct 29, 2017


Nothing seems obvious from reviewing the diagram. You might want to test the ignition switch for continuity to the start buss. 0900c1528006ae3f-nmkzohv23dbsppgyku1m4xn4-1-0.gif

1997 Dodge... • Answered on Sep 16, 2017


Check starter relays & fuses check all fuses for electrical modulesdrivers side inner finder electrical pannel for starter check all fuses and relays

1997 Dodge... • Answered on Sep 15, 2017


Sounds like the sun roof circuit breaker is tripping before fully closing. The C/B is in the fuse panel And looks like a fuse but is metal instead of plastic. The windows use the same style breakers. Change all of them, they are old. Also lubricate the tracks with lithium grease (spray can). Window tracks too.

1997 Dodge... • Answered on Aug 25, 2017


Try cleaning and tightening battery cables at both ends, A dirty or loose connection can cause this. Mike

1997 Dodge... • Answered on Jul 02, 2017


something else you have to have all of the original system in place for the ECM program to operate properly removing for convenience is not the way to go as it will throw up codes and upset the economy of the vehicle

1997 Dodge... • Answered on Jun 24, 2017


The Intrepid doesn't have a vacuum line. It uses a electric motor called a "blend door actuator". It's located on the underside of the heater box near the center of the car.

1997 Dodge... • Answered on Jun 14, 2017


That fluid and filter is due to be changed. The stuttering is evidence off low charge pump pressure at the reverse clutch pack . Filter service should be done every 80,000 miles.

1997 Dodge... • Answered on Jun 02, 2017


If the belt is installed and tensioner set, and the marks do not line up, you will need to do it over. All three marks, crankshaft and both camshafts, MUST be lined up for the valve timing to be correct. Once set properly, they will not change. Every two revolutions of the crankshaft, all three marks should again line up exactly.

1997 Dodge... • Answered on Nov 14, 2016

Not finding what you are looking for?
1997 Dodge Intrepid Logo

1,178 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Dodge Experts

Greg Bernett
Greg Bernett

Level 3 Expert

2993 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14874 Answers

Mike

Level 3 Expert

4377 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Intrepid Dodge

  • Intrepid Dodge

Most Popular Question

97 dodge inteprid 3 5 just replaced

  • Cars & Trucks
Loading...