Cfm Heating & Cooling - Popular Questions, Answers, Tips & Manuals
How to troubleshooting?
First of all, I am not a A/C repairman, but I do repair many other electronic devices. The first thing any repair person will need is a good service manual for the device, and I have found a link to one for you. I went over the site in quite a bit of detail, its a genuine Daikin site and rich with information.
Here is the link, and best wishes!
http://www.aircon-info.com/daikin-ac-service-manuals
Why does the split unit blow hot air in air conditioner mode, when switched on with the remote control.
because you have the temperature set at 28 degrees celcuis . Change the temperature to 18 degrees and it will cool 28 is hotter
It is a reverse cycle air conditioner it will warm the room if you set temperature to 28 degrees . Set it lower and it will blow out cold air.
Have exact same air conditioner as I recognise the remote control.
point it at the air conditioner when altering the temperature setting.
Check under the slide compartment also on the remote for more advanced settings.
What is error code H4
Hi don the error code is a system overload. There are a lot of things that could be causing this temperature short circuit. Inwould take the cover of the unit and see if you can visually see any maybe dust or debri on any condenser coils or fans. If you can't figure it out call an expert.
Here is a link to the manual for your system
http://www.supco.com/images/Seabreeze/New%20Material%202011/NEW%20MULTI-ZONE%20INSTALL%20MANUAL%2012-10.pdf
How too solve daikin error code c4
c4 error code has nothing to do with outdoor pcb. Use code 41 to check the value of the liquid line sensor and test with mulit meter. Pretty rare fault. Turn the power off for 5
Mins and reboot your system.
35,000 cfm = ?pounds trust
There is no equivilancy between the two...pounds of thrust would be 'foot pounds of torque' and cfm is the amount of air delivery is passing a specific sized opening in cubic feet per minute.
If you are looking at how much pressure is in for instance a residential air conditioning system, they are typically designed for .5"w.c. total system static. Meaning the pressure in the supply air duct plus the negative static added together cannot exceed .5" of water column. Approximately 28" w.c. per pound of pressure and we don't want any more than 1/2 of one inch water columm....
Now if you're talking about turbo-chargers....thats a different story and I haven't a clue.
What do symbols refer to ?
Are you sure the maple leaf isn't a snowflake?? The snowflake means cooling mode. The half moon means night time schedule and the waves mean the fan is on. The little flame indicates heating mode.
F1 flashing on split system
You need to determine what that code means by reading on your blower doors back side, there will be a set of codes pertaining to your make, model whatever that is as you did not furnish it.
Not finding what you are looking for?