...we have just moved it into my mum's kitchen to be used again. several points. did you put in transit bolts for move and forget to remove them? is machine sitting square on all four legs? is it ...
water wont drain my water wont drain, ny clothes are sitting in water can you manually set it to spin? if nothing happens when you do that then check your lid switch
...hollow and not steady - more like a bolt bouncing around on top of a running lawnmower. It just sits there vibrating sound. Sometimes it is just silent - nothing. It did work once on perma press ...
...I would begin by replacing the belt first. you may also have a problem with the clutch pulley which sits on top of the motor. if you remove the clutch you must replace the clutch clip as the old one ...
hotpoint washer my hotpoint aquarius extra wma40 won't start the cycle, but just sits with the wash, rinse + spin and final spin lights on. common problems with timer which work like a clock and goes ...
My washing machine drum wont turn. The washing machine fills with water then just sits with water in it. It will drain but wont spin It worked fine yesterday, but today nothing. When I turn the drum ...
It is not spinning check belt, remove top, (2 screws at rear), belt sits on plastic disc at rear of the drum, if not there it may have come off/ snapped. remove 2 screws in plastic cover and remove ...
Question about Aquarius WF220 Front Load Washer
...spin. I have tried to replace it and make sure the tension is correct but it doesn't seem to sit on the middle of the drum, it does seem to sit in the middle of the pully though (in the grooves) but ...
...first it has drain before it spins if the pump is ok then the cause could be the module board this sits at the back of the machine usually has a load of wires coming off it hope it helps regards ...
Question about WF430 Front Load Washer
...sit there till the program reaches the spin cycle and spins fine on the spin cycle. No problems with water draining ect no lights flashing seems to be stuck any ideas? Typical control board issue. If ...
Usually answered in minutes!
886 Questions
666 Questions
541 Questions
485 Questions
500 Questions