Questions & Answers for: Chevrolet Colorado how to remove the block

5 coil blocks remove the screw from the middle of the coil block and lift out. The spark plugs will down in the bottom of hole. When putting coil blocks back in the motor make sure to use contact lube

...remove hose and thermostat from the block. remember which way the termostat sits in the block and install new one. its always a good idea to flush your cooling system before putting in a new ...

...Remove the left front wheel and wheelhouse liner. Knock sensor (KS) (A), Engine harness (B), Knock sensor (KS) connector (C) Disconnect the knock sensor (KS) connector. Detach the knock sensor (KS) ...

...it fits into the bottom drivers side of the engine block right below the starter it has a single plug and is secured by one bolt , unplug it, and remove the bolt, pull it out using a twisting ...

Remove the thermostat housing from the engine block. Clean and inspect the thermostat housing. Clean and inspect the sealing surface of the engine block. To install: Position the thermostat housing to

...Remove fan shroud, belt, idler pulley, and alternator. 3.) Remove block side of lower hose and thermostat housing. 4.) Remove and replace thermostat. 5.) Replace everything in reverse

need to replace thermostat Chevrolet Colorado z71 4x4 Thermostats on I-4 and I-5 Colorado's are very straight forward, the thermostat and the housing are a single unit. Thermostat housing is ...

...remove the bulb. Look for the headlight connector to be melted or dis colored. If it is melted it can cause the headlight to not work an a new connector will need to be installed. Also check the fuse ...

...anything is blocked in there. if so or a bad ignition switch, you need disconnect the battery and remove the bottom dash plate from the steering wheel and you will have to disconnect the ignition ...

How do I replace the brake fuse on a 2005 Chevy Colorado? Fuse block is on the left side of dash. Remove cover, replace 'brake' fuse