20 Most Recent
Questions & Answers
On a 2006 chevy colorada 2.8 4cyl.truck how do you change oil pump
Remove the engine front cover. Refer to Engine Front Cover Replacement .
Remove the oil pump cover bolts.
Remove the oil pump cover.
Mark the inner and the outer gears in relation to the oil pump housing.
Remove the inner and the outer oil pump gears.
Remove the oil pump pressure relief valve plug.
Remove the oil pump pressure relief valve and the spring.
Clean and inspect the oil pump. Refer to Oil Pump Cleaning and Inspection .
view youtube videos
on Jan 14, 2021
2006 chevy colorado passlock comes on and stays
No, it can not be disabled.
The theft system is indicating a short term theft issue.
Have you added any "after market" remote start systems or alarms?
Insert the key in the ignition, turn the key to run position ( do not start ) and leave it in that position for 10 minutes. Cycle the key to LOCK position, count to 10, then turn the key back to run position and leave on for 10 more minutes. After the 10 minutes is up, repeat the procedure (1) more time and the security system will relearn the PASS code.
Give it a try and let me know.
on Dec 17, 2020
HOW TO REPLACE RADIATOR 2006 CHEVY COLORADO
I think you have a lot of room, look at what has to be removed, drain coolant, disconnect the hose remove fans, transmission lines they have o rings for leaking oil, use adjustable players to remove clamps, fill up coolant and let the air off by bleeder.
on Mar 16, 2019
My heater motor only works on high
A bad blower moter resistor can cause the blower to default to high speed only. The resistor is
located behind the lower right side of the dash on the heater box just left of the blower moter.
The fan switch can also cause this problem, but more often then not it's a bad resistor.
Hope this helps.
on Apr 29, 2018
If the PassLock light is on, there's a fault code stored in the computer. The ONLY way to turn off the light is to get the code and fix the problem.
on Jul 22, 2017
Not finding what you are looking for?