LEXMARK E342N HAS 200 PAPER JAM REMOVE CARTRIDGE MESSAGE. THERE IS ABSOLUTELY NO PAPER JAMMED IN THE PRINTER. HOW DO I FIX THIS? your sensor flag in the back is broken or missing Here is what probably
...lexmark printer E342N is reporting an error of 202 machine type 4511 please help!!! The exit sensor is either covered during POR or covered too long. Open the rear door to access the jam area. There ...
Lexmark W820 jamming at fuser? I have replaced the fuser and the pickup rollers in tray 1 and 2, the paper diverter in the output assembly because sometimes the paper would get caught in the teeth ...
...Fuser Lexmark C534 Fuser Exit sensor is never made. Possible causes: ? Improper loading of manual feed slot ? Paper wrapped in fuser ? Damaged paper exit sensor or paper exit sensor flag Gerrit ...
...lexmark x543 that always has the message "std bin full' when it is not. if you look where the black rollers are on the out put bin top rear of the printer to the left there is a flag this is what ...
dislodged. Look inside the cavity for a little black sensor arm and make sure it is moving freely. It should have a coil spring that moves it back when you flip it. Also check the back door for a flag
...Sensor Pic: http://support.lexmark.com/library/LEXMARK/MONO_HARDWARE/T65x_X65x/Exit%20Sensor.jpg & Narrow Media Sensor Flag Pic: ...
printer says tray 1 low, but paper is not low Most likely has something to do with the sensor the pick arm's flag. Try to check if the flag is moving freely. If it is, the sensor may need replacement.
printer is requesting remove paper/standard bin This means the flag in the output bin got stuck or there is some dirt in the sensor of this flag.
...flag sensor out of alignment where the paper comes out of the top. Look at the top f the printer where the paper comes out and you should see a black plastic sensor flag, it should move freely. If it ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions