Questions & Answers for: keypad work kitchenaid oven

...work for a day or two, then error message will come back on. These error messages, keypad and oven not working, beeping, short periods of oven working are all over a period of 6 weeks. F2:E0 is ...

KEYPAD STICKING AND STOPS WORKING MODEL:KCMS1555RWH KEYPAD BUTTONS NEED TO BE PRESSED REPEATLY TO OPERATE. THE PROBLEM SEEMS TO BE GETTING WORSE...NOT BETTER. Obtain a replacment keypad and replace it

...work then it means it is a shorted keypad and you need to replace Electronic Range Control/Clock(ERC). Please do rate the solution as "FixYa" if found useful and revert for further assistance. Thanks ...

...keypad short or motherboard fault if it is a KitchenAid microwave. Beware if you have a KHMS155LSS model, a Keypad short can and will cause the microwave oven to start on its own. A real stunning ...

keypad has no power. oven is not working Stove top is working properly. Oven is not working at all. Dgital keypad has no poweer Problem is most likely the control board. This is a pretty expensive ...

...work Several keys stopped working and replacing the keypad assembly had no effect. What's next? Replace the microcomputer? Yes! the whole keypad control board will need to be

work Keypad/keypads once faulty cant be fix . Buy a nex keypad a lot of time the problem with the keypad is the ribbon wire where it plugs in, if you unplug it clean it and put it back in, the numbers

...work. does keypad have a separate fuse? Main fuse box switch on and off, no results. Yes. Many of these have a display thermal fuse that is part of the wiring harness that connects to the board... it ...

...KitchenAid Microwave Convection Oven followed instructions on keypad but still not working Usually push click button than set time and push click button again (some will have you push the "start" ...

...work but all others do. How do I Check the connection between the touch pad (keypad) and control board (clock) to make sure it is secure. You have a bad touchpad. The ribbon cable is a failure point ...