...said model. H4 is a fuser temp error code. press"#" "interupt" "c" "interupt" these 4 keys. enter 14 , then press start Thermistor open The thermistor is open. The fusing unit is not installed. code ...
...Thermistor in the fuser unit or the code is false caused by power surge. To reset it, press P*C* and hit 14 start, then hit either ok or start again and machine chould reboot and clear code. If code ...
...thermistor or a board problem or a heating lamp issue. It requires service. Check the fuser unit for any debris or excessive build up especially around the thermistors - if you can remove and open up ...
...FUSER UNIT WITH SAME ERROR/CODE PROBLEM. Hi, check harness and connector betwen thermistor and control PWB. clear the error code by using SIM 14 if all didn't work you may have defective AC power ...
sharp AR-M205 copier H4 error fuser is not heated up.Check the fuser unit for broken element or open thermistor.Check the power supply
new fuser unit into a Sharp DX-C311. I get the following error code: H2-01 "Press # - Interrupt - C - Interrupt -14 - Start key Thermistor open The thermistor is open. The fusing unit is not installed
...thermistor in the fuser. Open door on right, three screws hold the fuser in (hot bit), release fuser slightly, being careful as it is still connected, the thermistor is sat in the top, you should be ...
...thermistor in the fuser. Clear the code from service mode. P * C * then 14 - Start then Yes then CA If the code comes back you must clean toner off the thermistor, or replace the thermistor or the ...
PRINTER ERROR CODE H2 SHARP AR-5620N There is a thermistor open. The thermistor controls the heat temperature. This is found in the fuser{ heat section} of the copier.
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions