No display DS10 running OpenVMS 7.3, it was powered down 3 months ago. On power up no display, no consol output on the serial port. Any ideas would be appreciated? hi sucb Clear nvram and replace ...
Ds10 problems Ds10 was working and at once it stoped.I took it and I looked what could cause the problem.It seemed tah the problem was coming from HDD and I changed it.But after I chenged and started ...
ALPHA SERVER DS10 with OPEN VMS 7.3 The server is not booting up. Currently when we start up: 1. it beeps 6 times. 2. the hard drive light remains on. 3. the fan light remains on. 3. it cuts off on ...
changed the mother board so MAC address has been changed comunication is not established now, how to insert the new MAC address in server, currently it is not communicationg with PLC Please help me, ...
...Compaq DS10 with a SBS PCI expansion connected and loaded with OpenVMS 7.1-2. When we add any type of network card DE500, DE504, etc...we get hangups and/or system freezes when trying to load TCPIP ...
Recognising floppy disk drive type on DS10 I have loaded VMS 7.3 on DS10, I entered command "show device/ful dva0" , vms say its a RX26, however the label on drive unit says RX23. I cannot initialise ...
...Compaq EVO DS10. There are two indented "spots" on the sides of the cover near the front. Push those in and the tabs should pop out. Then slide the cover about 1-2 inches forward and then it should ...
IP address change needed on a AlphaServer DS10 How do I change the IP address on a Campaq AlphaServer DS10 that uses OpenVMS First, identify the NIC you wish to change; use: $ MC LANCP <ret> >
how many OS supporting alphaserver ds10 HP Open VMS, HP Tru64 Unix, Linux, MS Windows
Question about AlphaServer DS10
Compaq Alphaserver DS10 when powered up, only the environment and power LED glow, on connecting using the serial cable, fail to see anything. a 2002 , 17 year old relic, why even mess with it. not ...
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions