My sharp ar5516 use to display h4, l1, h1, p1, u1, ch and i need the solutions to open them.

There's an earlier response to this question on fixya in Dec 4, 2012. Search "sharp ar5516 error code h4". It's the third hit down.

my ar5516s is flashing F 2 and CH

For H4 enter the following codes # interrupt C interrupt 14 Start button twice For ch check whether all the doors(side door,front door) are closed.


#Kintu Dennis Kentus

ch-
1.side door open
2.developing cartridge not installed
L1-
scanner feed trouble

Heat roller abnormally low temperature

L1-
scanner feed trouble &
CH-
side door open

The H4 code indicates the fuser may have blown the thermistor. It also could be a false error code. Try this series to clear the error and if it returns, then you'll know for sure the fuser is the culprit. To reset press the following buttons:

1. Press this sequence: CLR-Exposure-CLR-Exposure
2. The display will go blank
3. enter "14", press "PRNT"
4. Press "CLR" several times to exit.

Give that a try and good luck.

Sharp 8100 file of manual
http://files.mail.ru/N4G1OG
Please vote for me for my answer. Senks) Код ошибки Описание 0 Stepping motor 10 Mirror motor 40 Dark box switch 8 Mirror motor C1 Charge corona C2 Transfer corona C3 Discharge corona CH Interlock or thermal fuse CH possible DV unit not installed properly H1 Heater thermal fuse H2 Thermistor H3 High Temperature H4 Low Temperature H5 Lower thermofuse H6 Lower thermistor H7 High temperature in lower roller H8 Low temperature in lower roller L1 Forward Scan L2 End of Scan L3 Return of Scan L4 PT/main motor L5 Lens L6 Charge block switch P1 Copy lamp thermal fuse U1 Low battery U2 Data transfer U3 Dark box

code f5 for sharp al2030

Sharp AL-1553 code


E7 03 Scanner position error 04 Exposure lamp blown 05 CCD calibration error 12 White level calibration error 14 Main board malfunction 15 Exposure lamp blown L1 00 Scanner position error L3 00 Scanner position error L4 01 Main motor drive overloaded L6 10 Polygon mirror motor not up to speed H2 00 Fusing unit temperature error H3 00 Overheated fusing unit H4 00 The fusing unit doesn't heat up U2 01 Counter error 04 EPROM error CH blinking Dev unit is not properly installed