20 Most Recent
Sharp AR-5320 Black and White Copier Questions & Answers
What motor are you talking about the fuser motor, paper draw motor, the finisher motor, the transfer motor, the drum motor, the developer motor, corona wire transfer cleaning motor. I can go on.
Replacing developer and toner has nothing to do with the motor running, Btw, I’m available to help over the phone in case u need at
https://www.6ya.com/expert/normanj_7893313f0751935f
Sharp AR-5320...
•
Answered
on Mar 08, 2021
During installation , use sharp ar205 developer and sharp ar021 toner cartridge. This shows you did not use developer or used the wrong ones, good luck.
Sharp AR-5320...
•
Answered
on Jun 29, 2020
Man mean maintenance signal.
Reset : # - Interrupt - C -interrupt press 14 press start key.
If you are not fix try next way.
# - Interrupt - C -interrupt press 16 press start key.
Sharp AR-5320...
•
Answered
on Feb 13, 2020
Check fuser unit for rollers or exit sensor problems. Rectify the problem if its gear and replace. Then reset with code 14.
Sharp AR-5320...
•
Answered
on Jul 18, 2019
Sharp AR-5320 photocopier/printer is in share network. for each printing command ,its asking to install driver.and its taking more time for printing..
Sharp AR-5320...
•
Answered
on Jul 12, 2019
toner light needs to be reset.
(Then again you should throw out the old beast and get something new.)
Sharp AR-5320...
•
Answered
on Jun 04, 2019
how to reset the toner chip as it is costaly
Sharp AR-5320...
•
Answered
on Mar 15, 2019
L4 mean this copier main motor is not move or run.
First time, Open your copier back cover and check any gear is broken,solve it .Or clean all mechanical which one jam.If you are not a technician so you call a service Engineer who are qualified this Brand.
Sharp AR-5320...
•
Answered
on Jan 25, 2019
I Have a Konika Minolta bizhub 211. I had been trying this solution for repairing m2 call. but the code is appear till now. anyone help me. please give me solution step by step.Thanks
Sharp AR-5320...
•
Answered
on Dec 30, 2018
hi dear may you dont have put the origenal document proper or may be blank, just put writing side down on the glass or if u are using ADF put the writing side up side,
thanks
Sharp AR-5320...
•
Answered
on Jul 03, 2018
1. Entering the simulation mode
Perform the following procedure to enter the simulation mode.
"#" key "*" key "C" key "*" key
Main code 14 Start key Sub code 0 Start key
OR
"#" key "INTERRUPT" key "C" key "INTERRUPT"
Main code 14 Start key Sub code 0 Start key
2. Canceling the simulation mode
When the clear all key is pressed, the simulation mode is cancelled.
When the
* After canceling the simulation mode, be sure to turn OFF/ON the
power and check the operation. Btw, I’m available to help over the phone in case u need at
https://www.6ya.com/expert/normanj_7893313f0751935f
Sharp AR-5320...
•
Answered
on Apr 23, 2018
Hi,
this is a fuser error message. You must fix the problem causing the fuser to post an error. Then clear the message.
Sharp AR-5320...
•
Answered
on Dec 08, 2017
Not finding what you are looking for?
