Did the self clean today and now it beeps with f1 code on the display

This page has a bunch of fault codes .. check it out;
http://www.appliancehelponline.com/whirlpool.html

k

Does anyone know the answer? This was posted in October 2010! I ran the self clean too about a week ago. But we had a bunch of power outages last night. Today my oven has taken to beeping and flashing the F1 code. It is almost the same Model number. they wrote 9875XRB (not 5XRB) ...

i have the same problem and i need a solution. This never happened before until i tried to self clean the oven today, i hope someone has an answer soo!

My stove did the same thing after I cleaned it. I had to have the sensor replaced. That is what the F1 code is.

John

Hi

F1 error means that you have either a bad ERC (clock) or a bad touch pad. To check these please follow these simple instructions:

1. Disconnect power to stove
2. Gain access to the back of the clock (electronic range control or ERC).
3. Unplug the touch pad ribbon connector from the ERC. This will be a flat wire approx. 1 1/2" to 2" wide.
4. Make sure everything is clear and will not short out when power is turned back on.
5. Turn power back on to stove.
6. Watch for the F1 and listen for the beep.
7. If you get the F1 and beep, replace the ERC.
8. If after approx. 30 minutes you do NOT get the F1 and hear the beep, replace the touch pad...

thank u
rate me!!!

I have had the same problem and the machine is 12 years old - serviceman who came told me the console can be replaced for $400 - I am opting to purchase a new oven

I have a Frigidaire self cleaning range model PFEF385JHB1. The range is beeping and the display reads F1 locked. I can not find my user's manual. Please help! Nothing is working.

F-1 is a fault code.


Disconnect the power plug or turn range power off at circuit breaker. Wait a couple of minutes, then plug the range in or flip the range circuit breaker to ON.


Oven control beeps & displays any F  code error (for example 
F11) - Electronic control has detected a fault condition. Press 
CLEAR/OFF to clear the display & stop beeping. Reprogram 
oven. If fault recurs, record fault number. Press CLEAR/OFF & 
contact an authorized service agent. 

Error code F1 is for a defective touch pad or membrane (usually the touch pad). In this case you will need replace touch pad or membrane. It seems that water entered the touch pad during the self cleaning process, remove the touch pad and try to dry it. Good luck !!