Parental reset code

Go into the settings menu, Parental controls, reset parental controls. Click through the confirmation screens, and then it will give you a confirmation code and ask you to call Nintendo.

Instead of calling Nintendo, go to http://wii.marcansoft.com/parental.wsgi and enter the code. Even though it was originally written for the Wii, marcan's reset code generator will give you a valid code that you can enter into your DSi to remove the parental control.

For the Wii, if you don't remember your parental control code, you can reset it using a "secret question" answer. Since you bought it from a pawn shop, you probably won't know this either. In that case, you'll have to contact Nintendo Support, they can help you with the problem. Included below is a link to the page where you can contact Nintendo Support. Just scroll down the page and select the "Contact Nintendo" button, and there are step by step instructions from there.

http://www.nintendo.com/consumer/systems/wii/en_na/settingsParentalControls.jsp#reset

Good Luck!

have you tried 0000 -1234- other possible factory admin pass codes

I got a jvc tv-13142 at a pawn shop but some of the channel is blocked and i need a vchip code to unlock it i try all zeros and it show error how do i reset code

Hi there,
These instructions are from the model 25R-S100 but should work for you.
1)Press MENU to access MAIN MENU screen.

2)Press CH UP (8) or DOWN (9) to move the selection to “PARENT CONTROL”.

3)Press VOL (+) or (–) to access PARENT CONTROL mode, then “PARENT CONTROL V-CHIP BLOCK” is displayed.

4)Press and hold both VOL (+) and CH DOWN (9) on the TV set simultaneously until the message “INPUT SECRET No.” disappears.

have you tried just pressing x, until it fills up

There you go:
1) Hit [MENU]. Press [CH up / down] to select ?V-CHIP SET UP?, then hit [VOL up].
2) Enter 4-digit access code with the Number buttons. If you have not set up your personal access code, enter 0000 (default access code).

default passwords are often 1234 or all zeros that would be a good starting point

Ok first try 0 1 2 3 because that is the preset code for the ps2 or if that dont work insert any dvd movie, go to setup and access the parental control settings(press select) When asked for your code enter "7444"; It will prompt you again to type in your password. Type "0000" and then scroll down to the movie rating options and choose "off". Hope it helps you out!

When there is a parental code, you have to ring up your tv service provider for the code.