Blue outline of picture

Make sure Image Review is set in Custom Settings. See page 90 of this manual: http://www.fixya.com/support/p418-nikon_d50_digital_camera_with_18_55mm/usermanual-D690EED-pdf

Make sure Image Review is set in Custom Settings. See page 90 of the manual: http://www.fixya.com/support/p418-nikon_d50_digital_camera_with_18_55mm/usermanual-D690EED-pdf

Ur tv convergence board that was replaced for ur tv.The 2 STK convergence ICS was old it is not new it is those 2 STK convergence ICS on the tv convegence board is dead again and some of the resistors on the board maybe shorted and dies also must replaced too.The tv convegence board was put on ur tv those parts on the convergence board are old components parts,ur must repair tv convergence board again to fixed this problems called convergence pictures problems.

sounds like a bad video card or loose connection,check connection and then if that dont work replace video card..

when you are in the playback mode, you can use the zoom function (as you use it when you take a picture), this will zoom into the image you took.

the yellow frame show you where you are in the full image.

Have the convergence IC's replaced. Only one has failed but have both IC's changed as the other is not far behind..

Thx please leave comment

Sounds like a convergence problem. I can tell you that the site that Jean posted will not fix this problem and could even make things worse. That site pertains to a specific problem that is common in some Sony sets and should not be used to try to fix any other issue.

Please keep in mind many things can go wrong with TV sets and you should really do a lot of research before attempting any adjustment and or repair. There are high voltages present and they can reside even when the set is unplugged.

sounds like you may need repair man. convfrgnce circuit problem.  intergrated circuit resistors. not easy repair. 

convergance ic bad
http://home.earthlink.net/~oleg.filippov/ConvergenceFix.htm

reset the settings to factory default. the resolution and phase is off. also make sure the projector is not too close to the screen.