Whirlpool Cabrio Dryer Wont go past sensing light when I press start. The door is tightly closed and the filter is clean. It just won't even try to start it just just beeps once.

Sounds like a sensor is detecting something wrong and won't start the cycle until it senses all is well. Try checking that the door is closing properly. If the door sensor thinks the door is open, it can cause machine not to start cycle. Or check that the lower filter element is not clogged. Usually in the bottom of the front on the left or center of the machine is a little door that hides the filter screen for the drain. It should be cleaned periodically. Being clogged can cause issues. Hope this helps.

I would say that the lock has failed. Either the lock itself or maybe the pin or latch that fits into it when you close the door may have cracked / broken. If the machine thinks the door / lid is still open, it wont let you start it.

Start Switch is bad, When they go out it leave's a open circuit and all light will come on but no action.
After the circuit is closed then it tells the dryer to start cause the circuit activates both the timer and the motor.

Good Luck

Mike Z

-There are couple things that cause a dryer no to work:
-Thermal fuse, heater element, door switch, start switch.

Good luck

Mai

An EXTREMELY helpful technical guide is folded inside the console housing.
WARNING: It is for appliance techs, DO NOT do the voltage/resistance checks if you are not well-versed in troubleshooting appliances! BUT, it does include putting the dryer in diagnostics mode and checking the sensors.
Post back any error codes you may get.

The main electronic board has a fault and needs to be replaced.

http://www.partselect.com/dryer+dryer-wont-start+repair.htm

where are the answers on those stupid site

have a problem with my cabrio dryer its powered on but when i push start the sense like comes on and does nother whats the problem