B&d planer drive belt - Tools & Hardware - Others

Did you try Sears?

https://www.google.co.uk/webhp?sourceid=chrome-instant&rlz=1C1CHBD_en-GBGB719GB719&ion=1&espv=2&ie=UTF-8#q=Shopmate+drive+belt+for+hand+planer ..try this link..or try looking on ebay.

If the ball bearing of the armature was getting too hot by working with too hard woods may be the bearing of the armature can melting loss the drive belt have lost a little tension by it the housing and a bearing has to replaced in that case.

Do you mean replacing the cutter head drive belt?

With power off start the ribbed belt on the motor pulley, insert allen wrench into cutter head shaft. slowly rotate cutter head while feeding belt onto cutter head pulley. While rotating head, alternate between pulleys feeding it on one rib at a time. Softening the belt in hot water is NOT necessary to install the belt in this fashion.

Complements of
http://www.ereplacementparts.com/delta-22560-type-planer-parts-c-3275_3571_3579.html

Cheers

Billy of Hayward Delta 22 560 Type 1 Planer Parts

MRCARBOBONBRUSH.COM

http://www.ereplacementparts.com/delta-22560-type-planer-parts-c-3275_3571_3579.html Delta 22 560 Type 1 Planer Parts


Cheers

Billy of Hayward

If you're looking at the planer from the infeed side, there's a belt guard on the right side of the head. Remove it and check the condition of the drive belt. If it's broke the motor will spin without powering the cutterhead and feed rollers. The drive belt is still available as part number 22-563 on sites like http://servicenet.dewalt.com/ and www.ereplacementparts.com. Just put your model number in their search box and find the drive belt in the breakdown.

The pully which quides the belt must be perfectly level in both the horizontal and vertical positions. Use a metal square to check alignement and adjust using adjustment screws.

How to change belt on a ap10 thickness planer