AEG OKO Lavamat 74640 update wont spin. Pump and rinse works ok but doesn't spin.

Family error code "E20" means difficulties in draining, but I never heard for error code E25 on this model. Could be : E21, E23 and E24 error code.

Dado

Hello!

Error C1 on AEG Lavamat usually means that there is a trouble with water filling. The required water level is not reached.

I reccomend you contact your local Service
Force Centre.

Here is the link to a manual of a similar AEG Lavamat waching machine (a "trouble shooting" part). Hopefully, it will help!
http://manualsbrain.com/ru/manuals/1793433/?page=30

This is usually caused by the recycling pump running empty whilst the washing is still soaking up the initial fill water. as the water begins to soak the clothes it then starts to pass through the drum into the pump and the whole thing quietens down. running empty will not work. to test this theory try opening the drawer very slightly and filling it manually with a hose before starting the machine, (ONLY TO THE NORMAL LEVEL) and see if the noise is still as bad.

Reset using Off-2-Off.
Tested with Gentle rinse: water OK, but no drum rotation. Tested Short Spin: Pump OK but no rotation.
Opened door (first time) and rotated drum by hand - smooth.
Shut door carefully and tested short spin: OK.
Suspect: door safety switch. or I suggest you look at your instruction manual (or take the link below) and look at the fault bit of the book.

You could perhaps try to follow instructions for the "The washing machine doesn't work" .

Are you able to actually programme the machine? i.e. The display will still show you the programme length etc

It may sound silly, but is the door closed properly etc

Is there a way of resetting the machine, or maybe turn it completely off for a little while, and turn it back on?

If all this doesn't work, i suggest you phone either AEG, or the person/company you got the machine from, and get them to have a look at it.

Also, was it working properly, before it stopped working - i.e. Would it drain properly ?

I hope all this helps you. Source(s): http://www.serviceforce.co.uk/pdfs/U0346...

to clear the error code: whilst holding the pre wash and short wash buttons in together turn the control knob from off to gentle spin, this will clear the fault code and run a LED test. (if all goes weel) F9 means carbon brushes need to be replaced

Hello, to cancel the error C9 try to reset the machine by holding the start Button whilst turning the dial through 360 (from Off-2-Off).
Thanks

its a draining error, check sump, pump and drain hose for blockage failing that it needs a new pump.

Hi,

C9 Indicates Motor Fault. It seems that the Carbon Brushes have Worn out.

Replace it and more likely it would Fix the Problem.Once you replace that, you need to put the machine into Service Mode to Reset the Error.

Steps for Reset the Error Code

1. Press and Hold the Prewash and Soaking Buttons Together.
2. Whilst Holding them, Turn the Dial from Off one Click Anti Clockwise

Note - If problem persists, Check the motor plug for broken wires and check the state of the carbon brushes.

Let me know, if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

I have the same problem with my Oko Lavamat 74639 Update. I've tried changing the vacuum sensor, but no luck.
Did you get your fixed?
Olafur

What does the E40 error code mean?