AEG Washing Machines - Recent Questions, Troubleshooting & Support


I've had the same problem. The drum is held in place by a spring attached to a hole which forms part of the drum. If the hole where the the spring was has broken off, you'll have to get a new drum!!!!! A bad design for a machine which was very expensive. Mine even shows a message if it's been overloaded! Complained to AEG, naturally, they didn't want to know.
1_25_2016_10_01_18_pm.jpg

AEG Lavamat... • Answered on Jun 05, 2020


E40 relates to the door being left open when the programme is started, it maybe that the latch was not pushed over when the door was shut.After the door is closed again the fault should go away. If it does not and you hear alot of clicking from the door lock you may just have a door lock at fault.Code E40 is door not closed, could be a mis-aligned door or faulty door switch.-------------But if door is closing properly and you are confirmed that door is getting properly locked, then other possibility can be gunked filter or blocked drain pump.It requires cleaning internally.The procedure is as follows:--- Towards the bottom right of the machine is a pull-down flap.
Drain the machine - there's a tube at the bottom of the machine
with a plastic plug - you'll see a butterfly handle, pull hard; the plug
is a round ball on the end of a stick.
Unscrew the large diameter thing (pump cover) -
Don't do this before the drain step!!!
Withdraw the filter cylinder and remove any gunge - the
filter port has two ports - the left one is the impellor
pump and the right one is the discharge pipe; feel to ensure
these are not gunged up either.
Reassemble in reverse order - as Haynes say.
Almost every programme necessitates a pump activation to
assure that the machine is empty of water .-----------

AEG Lavamat... • Answered on May 26, 2020


try here?? http://www.aeg.co.uk/support/manuals

AEG Washing... • Answered on Oct 22, 2019


http://bastlman.wz.cz/2010/08/AEG-Lavamat-error-codes.html

AEG Washing... • Answered on Jul 27, 2019


All I have is the drawing of the electrical circuithttps://postimg.cc/yWz7SbYY
7_5_2019_8_25_08_pm.jpg

AEG Washing... • Answered on Jul 05, 2019


Ertor E62

Power relay to heater unit faulty.

Possible fault Heater unit faulty; Wiring faulty; Electronic board faulty.

Machine Status/Action Forced cooling cycle.

AEG Washing... • Answered on Jun 16, 2019


It is a communication problem between the circuit boards inside the machine. It might be as simple as unplugging and replacing the wires, or you may indeed require a new circuit board.

AEG Lavamat... • Answered on May 31, 2019


google AEG washing machine trouble shooting for answer.

AEG Washing... • Answered on May 04, 2019

Not finding what you are looking for?
AEG Logo

1,551 questions posted

Ask a Question

Usually answered in minutes!

Top AEG Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1482 Answers

john h

Level 3 Expert

23863 Answers

Michael Thomas
Michael Thomas

Level 3 Expert

3056 Answers

Are you an AEG Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...