Powers on and turns right back off - Polaroid FLM-2011 Television

1. Before starting, turn off the power with the power switch next to the power cord then disconnect the power cord.
2. Remove any data cables since you will be spinning it all around.
3. On my printer (other models may vary) there are 5 screws that need to be removed first:
Facing the front, open the large lower front cover and remove the three screws on the front right
Turn to the back and open the back cover. Remove the two screws on the left. Notice any screws that are different and remember their position.
4. Slide the right side cover towards the back. It should come away easily. Set it aside.

I think the motor controller circuit board is defective.

Check the Flyback Transformer and Hot. especially if its a soft ticking sound

Hi Hollings,

You description was very good, I need to ask for a specific.

When you turn to the left, the wheel is stiff like the engine is off or does it turn smoothly but the vehicle doesn't turn or seem to respond.

I'm trying to rule out broken mounts,

Also, if the wheel is all the way to the right, is it difficult turning back to the left the whole way, or half way. See where I'm going.?

Please comment back your findings

Best regards
Mike

I'm not sure what TV model you have. But, thing I can tell you is the most common problem.
Most of the time with flat panel TVs, the power supply for the screen fails. And the TV normally turns itself off to protect other parts in the TV from being damaged. Basically " Protection Mode".

You can try leaving the TV unplugged for 30 minutes so the TV can reset itself; then try again turning it on. If it doesn't work after that, it's time for the TV repair shop.

If you wish to eliminate or reduce the volume of the end of cycle beep you can do so by powering off the unit and turning back on while holding the right button “Cancel/Reset”. The beep has 3 volumes levels and silent, press the right “Cancel/Reset” button to cycle through the settings. Power the unit back off to save you setting.

60PL9200D/37 When I unplug it for a while and turn it back on, the picture starts to come on, but it turns dark. And the red lights on the left and right side of the power button blink. Sound but no picture.

blue come on tv do not red llight come back on

Is this for a ps2 or ps3?

Take off back cover. The problem power board is to the right of the board where the power plug feeds into the TV. There is a large white fuse right bend the power plug. With a meter it read ok; about 8 inches deeper into the TV on that board was the resister next to two fuses. My 4 amp 125 volt fuse did not read on my meter. After replacing, it worked fine.