Question about Frigidaire Affinity ATF7000E Front Load Washer
I'm not sure on the product. The model is FAFW3801LW3
IF there is an E attached to the 45, it is your control board and the control board would need to be replaced. This is per the "Washer Tech Data Sheet"Hope that helps...
Posted on Jun 19, 2008
I fixed this myself and it only took about 5 minutes. The problem is the door latch needs to be reset, which requires unplugging it's three electrical connections. This has to be done inside the washer outer seal, but it is easy to get to. First remove the outer ring that holds the seal on. Next remove only the side of the seal closest to the door latch (again only the outer seal needs to be undone). With this done remove the two screws holding the door latch in place (inside). Remove the latch, unplug the three connectors, plug them back in then reassemble everything. When all is back in place hit "cancel" and it should be good to go.
Posted on Jan 10, 2009
Tips for a great answer:
Nov 23, 2015 | Frigidaire Affinity 5.8 Cu. Ft. Gas Dryer
Hello Larry Occhipinti, thank you for your post!
If you are pushing the necessary buttons on your Frigidaire washer to perform a system clean and they are not working, it could be a possible issue within the control panel. I would recommend a reset on your appliance which can be done by disconnecting power from your appliance for roughly ten minutes. If that does not correct the issue, you can run a hot water wash cycle with a cup of bleach inside the tub to clean your appliance out as well. I hope this is helpful. -Matt
Aug 31, 2014 | Frigidaire Affinity ATF7000E Front Load...
Jul 19, 2014 | Frigidaire Fafs4474lw Affinity 3.81 Cu Ft...
Jul 08, 2014 | Frigidaire Affinity ATF7000E Front Load...
Feb 21, 2012 | Frigidaire Affinity 5.8 Cu. Ft. Gas Dryer
Dec 18, 2011 | Frigidaire Affinity ATF7000E Front Load...
Nov 27, 2017 | Frigidaire ATF6000ES Front Load Washer
Jul 26, 2011 | Frigidaire Affinity ATF7000E Front Load...
Jan 21, 2010 | Frigidaire ATF6000ES Front Load Washer
306 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: