Question about Frigidaire Fafs4474lw Affinity 3.81 Cu Ft DOE 4.4 Cu Ft Front Lo
What do you put in the clean tub option keeps blinking
Hello Jodi, thank you for your post!
Your Frigidaire washer (FAFS4474LW0) will automatically prompt you to run the CLEAN WASHER cycle typically every 50 cycles. If you wish to begin the cycle, press SELECT when prompted. This maintenance cycle uses hot water and two rinses to remove residue that may cause odor. For best results, I recommend to use the CLEAN WASHER cycle once a month
You may press the CANCEL button to manually perform the cycle at another time if you prefer. You can do this by following these directions:
·Rotate cycle knob to Rinse & Spin
·Then press the CLEAN WASHER option button
·The LCD screen will display "SYSTEM CLEAN"
Hope this helps! - Z
Posted on Jul 22, 2014
Tips for a great answer:
Hello Larry Occhipinti, thank you for your post!
If you are pushing the necessary buttons on your Frigidaire washer to perform a system clean and they are not working, it could be a possible issue within the control panel. I would recommend a reset on your appliance which can be done by disconnecting power from your appliance for roughly ten minutes. If that does not correct the issue, you can run a hot water wash cycle with a cup of bleach inside the tub to clean your appliance out as well. I hope this is helpful. -Matt
Aug 31, 2014 | Frigidaire Affinity ATF7000E Front Load...
Oct 30, 2011 | Frigidaire Affinity ATF7000E Front Load...
Apr 06, 2011 | Frigidaire Affinity ATF7000ES Front Load...
Apr 15, 2010 | Frigidaire Affinity 5.8 Cu. Ft. Gas Dryer
Jan 21, 2010 | Frigidaire ATF6000ES Front Load Washer
Mar 21, 2009 | Frigidaire Affinity ATF7000E Front Load...
Dec 01, 2008 | Frigidaire Affinity ATF7000ES Front Load...
Jun 05, 2008 | Frigidaire Affinity ATF7000E Front Load...
Apr 20, 2008 | Frigidaire Affinity ATF7000E Front Load...
148 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: