My fisher and paykel MW511 washing machine stops at the start of the spin cycle.

Hi,

Please power cycle your washing machine by unplugging your machine for 1 minute before plugging it in again.

If this issue reoccurs , then please check that there are no debris at the bottom of the washer. And you can double check whether the washer door is being shut properly.

Thank you.

have Fisher and Paykel GWL11 it stops during the rinse

probably has water in circuit board use dryer in general area for 10 mins

Size setting
Action - Reselect the size of Smartdrive by using the SIZE SETTING MODE. Push and hold
the water temp up button, then press the power button to enter SIZE SETTING MODE. Three
LEDs are used to identify size.
The cold water temperature LED identifies 5kg.
The low water level LED identifies 6kg.
The hold spin speed LED identifies 7kg.
If the product has not been setup before all 3 LEDs will be on.
To set the size for 5kg push the wash temp up button then
the power button.
To set the size for 6kg push the water level up button then the power button.
To set the size for 7kg push the spin speed up button then the power button.
This locks the size
into memory. To check the size is set, start a cycle.

Turn power off AT THE WALL,under the wash bowl Spray some wd40 on to the pump at both ends, while this may stop it for a while. Your pump may well be on its way out. you should replace for a new one. bad pumps can cause more problems problems .

Hi blow down the hose that the waste water comes out of, it may be blocked

ok guest you can set a fisher and paykel machine to skip one rince cycle so as to save water,

Check the pipes actually work first. Is there a hidden drain filter that is partially blocked? Dissasemble the pump and check it works and the blades inside are clean.

check out the DRAIN MOTOR PUMP , its a small motor with 2 hoses connected to it , it could be clogged , need to remove it , inspect inside the impellers for any debri , clean it , re install and try again , hope this helpful AJ

Having the same problem. Any ideas at all? It's really frustrating.

nwesthamz
Rank: Apprentice
Rating: 75%, 1 votes
mw511 fills with water but cylinder isnt spinnig and when it stops filling nothing happens. However sometimes it will go complete cycle ans a noise can be heard on spin cycle even though it is not spinning. As thoiugh the motor is not engaging with the cylinder
Was this helpful? Yes No