20 Most Recent
Fisher and Paykel Fisher & Paykel Washer Questions & Answers
What does fault code 002 mean on a WH80F60W1 Front
Hey mate - Fault code F002 on these front loaders refer to some heating issues within the machine, it be anything from a loose wire - faulty NTC sensor - to a stuffed element and worse case the control PCB unit.
My Model GW712 won't spin or drain Top loader
hi there the first thing ill tell you is that the washer needs to drain water before it can spin there are only a few factors that prohibit this operation a faulty lid switch secound a blown or blocked water pump being a fisher paykel they are famous for jammed water pumps as they decided when they built the sysyem to turn the water pump upside down this causes a lot of stress on the water pump see if you can lay the hose on the ground and get all the water out i belive the machine will then start to spin dry. in this case it is the water pump and have it replaced its a simple operation if you can order the part fromf/p you simply turn the washer on its side depress the white latch next to the pump turn the pump clockwise till ity release from machine disconnect power supply plug and fit new unit as per reverse
best of luck
sonic boom electronics australia
Hi... I have a F+P
did you wheck the windings on the pump if they are discoloured in any way replace it they get hot smelly and then blow the main board
I have a Fisher &
burning smells are most common from the drain pump remove and sniff it if it smells like its been getting too hot replace it
My Fisher & Paykel smart
this sounds like a computer error asthe first and last lights is an error code 129 which does not exist if its the first and second to last light then its a sensor fault
How to clean pump from smartdrive 501?
there is no cleaning as such,but if your havig drainage problems then remove pump check for anythining that might jam it and lookat the electrical windings for any discoloutation if there is replace pump
What does fault code 51 mean
if you have a 51 fault the machine must be a diverter valve model machine which has a water save function,check the diverter has nothing jammed in it and that the soleniod is ok with a multi meter if it passes both checks then it your main computer board
Smart drive 601
If it is out of balance it will automatically return to a wash cycle to try and redistribute the clothes more evenly. Maybe the out of balance switch is faulty. More likely though is a faulty control board. If that then get a new washing machine. That model is over 20 years old. Not worth spending money on it.
My washing machine was on
Could be a overheating pump. hope you got it checked out! probably blew the board when the pump went.
Not finding what you are looking for?