Camera will not switch on - Moultrie GameSpy 4.0 Digital Camera Deluxe

In menu option C.Fn-12 you can choose to switch the display off (or on) when you switch on the camera. The display stays off even if you switch of and on the camera.
Press the button <DISP> and switch off the camera, while the settings for recording are on the screen. After you switch on the camera, the LCD screen will be switched on again.
Please refer toy your english manual, I had to translate, because I don't have the English version.

Remove the batteries and press power and hold for 30 seconds, replace battery and power on.

If "Err" is displayed on the LCD panel on the top of the camera when the "MENU/EXE" button on the FinePix S1 Pro is pressed, check the following:

<If "Err" is not flashing>

1. If the slot cover is open, switch the camera off, close the slot cover and switch the camera back on.

2. If the remaining charge in the AA-size batteries is low, switch the camera off, replace the batteries and switch the camera back on.

3. If steps 1 and 2 above do not remedy the problem, contact the store where you purchased the camera or your nearest authorized FUJIFILM repair center.

<If "Err" is flashing>

1. Pictures cannot be taken because the remaining charge in the lithium batteries is too low or because the camera mechanism has stopped operating due to the camera being used in cold conditions.

In this event, switch the camera off, replace the batteries and then switch the camera back on. If replacing the batteries does not resolve the problem, set the focusing mode to "M" and release the shutter before switching the camera off briefly.

2. If step 1 above does not resolve the problem, contact the store where you purchased the camera or your nearest authorized FUJIFILM dealer.

Please click here to download the manual for Fuji FinePix S1Pro .

You must have Adobe Acrobat Reader installed to view PDF files. The reader is a free plug-in available at the Adobe web site.

If this is a brand new camera, it's supposed to work with no problems. Take it back.

duo to memory full

you can't switch off the web camera
but you can disable the camera that means the camera turn off
open the device manager
and imaging device and select the camera then right click and disable the device.

I just gave it a very hard tap against my dinning table and it became alright!

The camera was working fine 5 days ago. Yesterday when I tried to switch it on, I assumed that the battery was flat so I charged it but when fully charged the camera still won't switch on. i Please help!

Make sure that the mode switch on the cover is in the playback position. Unfortunately, I don't have a source for new switches.

It sounds like a bad connection with batteries or battery holder or a loose cable somewhere within the camera. Maybe even a dry solder joint or intermittent fault with the power switch. Unless you know your way around the innards of your camera I'd recommend a qualified tech to take a look. BMW