Pump motor screeching - Hayward 3/4hp Super Pump Inground Pool Pump 115/230 Volt # Sp2605x7

Maybe impeller has debris in it or is bad or bad motor bearing

Possibly a bad bearing in the tilt motor? Try disconnecting the motor from the tilt mechanism if possible then operate the motor. If it makes noise but less of it, it will be because it is no longer under load. Good luck.

The starter needs to be replaced, since it is on it's way out.

Chances are you either have something stuck in the impeller (not likely), or your motor bearings are worn out. If the latter is true, you are about to lose the use of your motor.
Depending on your motor, you may be able to have the bearings replaced. Otherwise, you may be looking at a new motor.
When the bearings on mine were going out (mine are non-serviceable), I just continued to run the motor til it completely failed. Then I replaced it.
If you are the "do-it-yourself-er" type, it is much cheaper to order a new motor online and change it out yourself. Takes less than 30 minutes. Be sure to replace the shaft seal when you change out the motor. I replaced my Sta-Rite Duraglas (A.O.Smith) motor and seal for $150.
Hope this helps.

Most likely bearings. They will eventually break down. You might find someone in your area to replace them ... I suggest you find a back up motor.

Hi kootchbol
Sounds like you have a faulty bearing that is causing your noise and a leaky seal on the back of the pump between the motor and the pump
Please rate me
Bud

Hello & Welcome to FixYa

The problem is with the impeller or the chopper assembly that is causing this screeching noise. You can take apart the bottom front access panel and clean the drain pump assembly completely and check for any broken parts inside that need replacement. If the problem returns then replacing the impeller/drain pump-motor assembly is recommended repair. Please get back to me if you have any other questions.

Kevin

The usual "screeching noise" in these washers is most often from the pump. Tilt the machine up so you can get the belt off (no tools required) and then turn all three of the pulleys. The center pulley is the transmission, the movable one is the motor and the last one is the pump. You will probably be able to feel or hear the noise and take appropriate actions. Good luck. AJ

Should you have to use un due force to get the filter undone on the Hoover 1300 special deition washing machine