Replace heater element

Disconnect the defrost element and check with a multimeter for continuity. If there is no continuity, the element has failed. If the element is good, check the connections.

There is usually a Defrost Timer, but this uses a Defrost Sensor. Put 'defrost' into the Parts Search.

Heater
https://www.searspartsdirect.com/product/2i5x3d492k-0046-795/id-mee62105201

Sensor
https://www.searspartsdirect.com/product/1ff3ug3vf2-0046-795/id-acm73919201

https://www.searspartsdirect.com/model/2eozk34nvj-000583/kenmore-elite-79572053110-bottom-mount-refrigerator-parts

Timer normally
https://www.google.com/search?q=Kenmore+Elite+refrigerator+795.72053.110+defrost+timer

For Control Board replacement, I always advise getting a service call due to cost and warranty.

..

F44 indicates a heater relay fault; the heater cannot be turned on. First check the heating element or the wiring for the element. If there is a problem with these, replace the part(s). If the heating element and wiring are good, then you need to replace the entire electronic control board. The relay is on that board.

Unfortunately, the control board is no longer made. The parts diagram is available here: https://www.searspartsdirect.com/model/3ky9drdxaj-000583/kenmore-elite-11028082700-washer-parts . The heating element is shown as part 15 on the motor, basket and tub parts diagram. The electronic control board is part 1 on the control panel parts diagram.

I hope this helps.

Cindy Wells

Kenmore Elite C970 440935 Replace heating element range

www.fixya.com > ... > Ovens > Kenmore > Kenmore Elite C970 440935
Kenmore Elite C970 440935, replace heating element range related issues. Get free help, solutions & advice from top Kenmore experts. ... Kenmore 40494 / 40495 / 40499 Electric Single Oven. 793 Questions ..

check heater element

FIRST UNPLUG dryer from wall then remove the back of dryer and you will see the square heater and two screws holding it in place,remove wires and replace heater and reconnect the wires.

Possible that the heater element is faulty , the line to the heater is snapped or bitten off, the relay to the heater switching is faulty or failed or there is fault in the program switching.
You need to check out one by one using a multimeter, check the continuity of the element if not check the voltage to the heater which will give an indication to the above issues.

Hi,
Check your heating element..

A bad heating element causes many problems in dishwashers...

Dishwasher Problems The Heating Element not Working

How to Replace the Dishwasher Heating Element

Dishwasher Maintenance

heatman101

Asker's Testimonial " explanation very clear. will give it a go and see how simple it was. thanks Ronnie " - ronnieshomes

heater element needs repair but usually replacement

you probably need a new heater element.

post your email i will send you the manual on it.. also post the complete model number from the unit